Go back to home

DBW Throttle

Author
zmit
MR2 Aficionado
  • Total Posts : 664
  • Scores: 15
  • Reward points: 5005
  • Joined: 4/7/2011
  • Location: Adelaide SA
  • Status: offline
Wednesday, January 29, 2020 10:51 AM (permalink)
0

DBW Throttle

Hi all,
I'm in the process of going DBW throttle with my Gen2 3SGTE. I'm running a Link G4+ that has been modded to support it.

I started looking at a 2ZR throttle body, but the dimensions were too difficult to make work. Since then, I got some information that the 2AZ throttle body has a 65mm opening reducing to 55mm on the manifold side. Bolt pattern appears to be the same too!
I've got a Gen1 3SGE intake that I'll be bolting it to.
 
Does anybody have any experience with DBW throttle on a 3S that might be able to shed some light on how they've done it or what TB they used?
 
Cheers,
Tim

1992 SW20 GT
... and loving it...
#1


2 Replies Related Threads

    just_ace
    Moderator
    • Total Posts : 2508
    • Scores: 89
    • Reward points: 4598
    • Joined: 4/7/2011
    • Location: perth wa Australia
    • Status: offline
    Re: DBW Throttle Thursday, January 30, 2020 8:03 AM (permalink)
    0
    Havent actually fitted mine yet, but imho, just grab a new bosch unit. They're not that expensive. You can get weld on ally flanges with o rings so no gasket needed to.
    #2
    Guest
    MR2 Enthusiast
    • Total Posts : 36
    • Scores: 0
    • Reward points: 1547
    • Joined: 4/6/2011
    • Status: online
    Re: DBW Throttle Saturday, February 01, 2020 10:41 AM (permalink)
    0
    Drive by wire throttle body will work, as in Nissan or Toyota etc. Corrola are small from memory.

    I haven't heard of any being bolt up, you need to see a welder to put on an adaptor plate.
    #3

    Jump to:
    © 2025 APG vNext Trial Version 5.5