Slight change of plans for this aw11 also, I'll continue rebuilding this smallport, but it wont be going into this aw11, will be going into my white one :-). 
This one will be getting a full rebuilt 4age bigport put back into it.  
 

So finally started pulling this 4age down for a full rebuild.
Have ordered & received nearly all parts.
Few more parts are heading off to the machine shop :-)
 
More to come!

Phew, I thought there was a glitch in the matrix for a second there. Again looks good. You painting the lettering then masking it off for the rest of the paint?

Small update:
 
Got parts back from machine shop,



 
Installed the new bearings, place crank in, piston, rods, then found out the rod bearing were not the same size a smallport (4B1780), bigport are actually smaller in size, so I quickly hunted a set down & installed them (part no. reference: 4B1710 STD).
 

 
Now just waiting on some more time to finish this build off, hopefully be this coming long weekend.

 
 

fredhoon
Mike are you going to compete in this car down a WPC17 or the SW20?

yeah atm that's the plans. If for some reason i run into any issues ill bring over a couple sw20's instead. But planning on bringing both adubs over ☺

Bit more progress.
 
Installed new drive shaft axle seals both drivers & passenger side.


 
Last bit of main wiring harness routing & connections



 
Ready now for installation :-)
 

Good work Mike, progress tracking well for MTC?

Got engine installed today, went very smoothly, all bleed and running beautifully ;-)
  
 
 
Some home made door skins


 
New deep dish steering wheel fitted.

 
Run in time :-)