Go back to home

My gearbox issue.. please look.

Page: < 123 Showing page 3 of 3 - Powered by APG vNext Trial
Author
SAW4397
MR2 Enthusiast
  • Total Posts : 87
  • Scores: 2
  • Reward points: 2057
  • Joined: 2011/05/04 19:56:08
  • Status: offline
Re: My gearbox issue.. please look. 2013/11/26 16:53:33 (permalink)
0
Another problem dealerships do should just make the mechanic work until its done pulling someone on and off causes problems always.

Hopefully when you get it back there is no dramas with it so the best of luck.
#31
IMR22C
MR2 Aficionado
  • Total Posts : 673
  • Scores: 13
  • Reward points: 3577
  • Joined: 2011/04/07 19:51:15
  • Location: Newcastle NSW Australia
  • Status: offline
Re: My gearbox issue.. please look. 2013/11/27 10:33:01 (permalink)
0
SAW4397
Please tell me you at least checked them? with torque wrench or something? Also it was the pressure plate may I remind you that this is usually only torqued to something like 40nm or less depending on the pressure plate so using a rattle gun is ****ing overkill not to mention there is a sequence for them.



Yeah I'd never use a rattle gun on a pressure plate because they need to be tightened down evenly.
But again, never once did I torque them, just tightened evenly with a 3/8" drive and socket. (and then double and triple checked)
#32
Gatesys SW20
Supporter
  • Total Posts : 1106
  • Scores: 22
  • Reward points: 1110
  • Joined: 2012/11/06 19:28:18
  • Status: offline
Re: My gearbox issue.. please look. 2013/11/27 11:57:14 (permalink)
0
picked car up yesterday!
All is good clutch bites nice, like a new clutch should,
break in period commencing, will doble check after 1000kms with them everything is sweet!

only issue, my wheel alignment at the rear is screwed, so have to getr that redone :(
#33

Page: < 123 Showing page 3 of 3 - Powered by APG vNext Trial
Jump to:
© 2025 APG vNext Trial Version 5.5