Go back to home

garage clean out WA.

Page: 12 > Showing page 1 of 2 - Powered by APG vNext Trial
Author
just_ace
Moderator
  • Total Posts : 2508
  • Scores: 89
  • Reward points: 4598
  • Joined: 2011/04/07 19:51:15
  • Location: perth wa Australia
  • Status: offline
2012/04/16 14:06:23 (permalink)
0

garage clean out WA.

need to get rid of all unnecessary parts, to this some will mean i'm no longer the go to guy for parts. will most likely ad more parts as i org my crappy garage. large items i cannot be bothered with posting at the moment unless you offer extra financial incentives. prices ONO how ono greatly depends on the object, how much i want it out of my face and the effort involved in getting rid of it.

located in WA

celica parts:
st184 bonnet red, no dents last time i looked doesnt have the black front edge strip $50
st185 ATA bonnet black, needs a respray, vent damaged. $50
st162 rear king springs STD H $40
st162 front seats $50 series 1 grey. pretty good nick bar head rests.
st162 SS rear muffler section (see pics) 2.5in this is from 5yrs ago when i had my first st162gt2 only seen 500k's. may need so modding to fit stock celica as i had 3in custom that it connected to. $100
st202 3sge gearbox s54. these have better synco's than the earlier boxes, this won't fit st162 due to the elec speedo sender. same ratio's as st162 s53 (ie shorter ratio's than std celica's with 5sfe) $350
7th gen rear spoiler, stock blue colour $100
gen2 coil packs, or 5sfe. will check part numbers. $20 each
series 2 driving/fog lights with bracket and switch $100

misc:
SS hard water lines suit gen2 water pump housings. some of the earlier ones weren't SS and corrode. i have 3 (see pic) $50each
1 gen 2 3sgte
1 gen2 3sge
1 5sfe with oil cooler

various timing belt covers, mainly gen1/2 3sge, may have gen2 gte bottom covers. $10 each
gen2 3sgte bottom end, out of my st185 BHG suit full strip and rebuild $50
gen3 sump. all 3 pieces, ally, steel and windage $150
3x TVIS GTE manifolds. i have 1xgen1, 1x gen2 and another gen2 that has the opening bored to suit a 65mm TB. $40each
TVIS plates with TVSV+TVIS elec solenoids
beams 3sge inj's believe only 315cc or 340.
COIL packs with bracket to suit gen2 with pig tails and new connectors to make custom leads $250
HKS elec boost gauge, i seem to remember sometimes it wouldn't work, may have been my dodgy wiring. has peak hold function $50
 

sw20 mr2:
eng lid under cover, with stay and intact clip. $50 no postage
underbody covers free
boot carpet
rev 3 spoiler, white suit repaint $100
rev1/2 boot opener
rev1/2 tail lights 2 pairs, 1 pair has red tape under the brake light section that is pealing, once removed they'll look sweet. no deep scratches or cracks. $30 a pair $20 for the center panel
rev3+ booster(from b24 96's gte) $100
JDM drivers window mirror control. clip broken on the underside. $10
set rev1 calipers. $50 
black side vents, 1 mounting area damaged.
 
 
post edited by just_ace - 2012/04/18 10:27:54
#1


18 Replies Related Threads

    just_ace
    Moderator
    • Total Posts : 2508
    • Scores: 89
    • Reward points: 4598
    • Joined: 2011/04/07 19:51:15
    • Location: perth wa Australia
    • Status: offline
    Re:garage clean out WA. 2012/04/16 14:14:17 (permalink)
    0





     
     



    post edited by just_ace - 2012/04/18 10:33:05
    #2
    midnightgto
    MR2 Enthusiast
    • Total Posts : 26
    • Scores: 0
    • Reward points: 186
    • Joined: 2012/02/03 01:10:13
    • Status: offline
    Re:garage clean out WA. 2012/04/16 14:14:45 (permalink)
    0
    how much for the sw20 boot carpet is it in good condition ?
    For the tail lights, is that the circular one or the square like one.
     
    Could you send pics  of border skirts, carpet and lights to geoffrey365@iinet.net.au or post them. 
     
    cheers
    #3

    midnightgto
    MR2 Enthusiast
    • Total Posts : 26
    • Scores: 0
    • Reward points: 186
    • Joined: 2012/02/03 01:10:13
    • Status: offline
    Re:garage clean out WA. 2012/04/16 14:27:05 (permalink)
    0
    how much for sw20 boot carpet
    #4
    artymr2
    MR2 Deity
    • Total Posts : 1105
    • Scores: 45
    • Reward points: 7867
    • Joined: 2011/04/07 19:51:15
    • Location: WA
    • Status: offline
    Re:garage clean out WA. 2012/04/16 15:01:41 (permalink)
    0
    Can I grab the under body plastic please , after the curved piece that direct air into the engine bay, do you have this?
     
    Cheers
     

    Black SW20 GT Turbo T-top


    #5
    P E T E
    MR2 Aficionado
    • Total Posts : 275
    • Scores: 10
    • Reward points: 4436
    • Joined: 2011/04/07 19:51:15
    • Location: Perth WA Australia
    • Status: offline
    Re:garage clean out WA. 2012/04/16 16:15:37 (permalink)
    0
    I'm keen on the undercovers dependent on condition. I don't need the undercover that Arty is Chasing however :)
     
    Do you have in particular the two covers that go just below the radiator fans?

    > P E T E <
    #6

    P E T E
    MR2 Aficionado
    • Total Posts : 275
    • Scores: 10
    • Reward points: 4436
    • Joined: 2011/04/07 19:51:15
    • Location: Perth WA Australia
    • Status: offline
    Re:garage clean out WA. 2012/04/16 16:17:48 (permalink)
    0
    Oh, also possibly interested in the Toms Front and side skirts :)

    > P E T E <
    #7
    just_ace
    Moderator
    • Total Posts : 2508
    • Scores: 89
    • Reward points: 4598
    • Joined: 2011/04/07 19:51:15
    • Location: perth wa Australia
    • Status: offline
    Re:garage clean out WA. 2012/04/16 19:01:51 (permalink)
    0
    pic of what i have of under body plastics
     

     
    pete have had someone contact me already re body kit parts, let you know.
     
    #8
    artymr2
    MR2 Deity
    • Total Posts : 1105
    • Scores: 45
    • Reward points: 7867
    • Joined: 2011/04/07 19:51:15
    • Location: WA
    • Status: offline
    Re:garage clean out WA. 2012/04/16 19:11:31 (permalink)
    0
    Cant tell from the pics if the seperate part is the curved piece I need (looks like it is), would like to grab it and the other rear most part also.
     
    Please let me know.
     
    Cheers
     

    Black SW20 GT Turbo T-top


    #9
    just_ace
    Moderator
    • Total Posts : 2508
    • Scores: 89
    • Reward points: 4598
    • Joined: 2011/04/07 19:51:15
    • Location: perth wa Australia
    • Status: offline
    Re:garage clean out WA. 2012/04/16 19:16:56 (permalink)
    0
    yes, the back most bit is supposed to curve up. i'll set those 2 pieces aside
    #10
    just_ace
    Moderator
    • Total Posts : 2508
    • Scores: 89
    • Reward points: 4598
    • Joined: 2011/04/07 19:51:15
    • Location: perth wa Australia
    • Status: offline
    Re:garage clean out WA. 2012/04/16 20:11:31 (permalink)
    0
    boot carpet could do with a steam clean, but no tears etc afaik
    #11
    chase_d
    MR2 Deity
    • Total Posts : 1015
    • Scores: 45
    • Reward points: 5468
    • Joined: 2011/04/07 19:51:15
    • Location: Perth WA Australia
    • Status: offline
    Re:garage clean out WA. 2012/04/16 21:54:42 (permalink)
    0
    Second in line for side-skirts if Pete doesn't want them

    ________________
    1993 Toyota MR2 GTS
    1993 Toyota Supra SZ
    ________________
    #12
    midnightgto
    MR2 Enthusiast
    • Total Posts : 26
    • Scores: 0
    • Reward points: 186
    • Joined: 2012/02/03 01:10:13
    • Status: offline
    Re:garage clean out WA. 2012/04/16 22:46:11 (permalink)
    0
    cost for boot carpet please
    #13
    just_ace
    Moderator
    • Total Posts : 2508
    • Scores: 89
    • Reward points: 4598
    • Joined: 2011/04/07 19:51:15
    • Location: perth wa Australia
    • Status: offline
    Re:garage clean out WA. 2012/04/18 10:35:08 (permalink)
    0
    list edited. sold parts removed.
     
    re:boot carpet, at the moment can't be bothered posting. it's free for local pick up.
    #14
    P E T E
    MR2 Aficionado
    • Total Posts : 275
    • Scores: 10
    • Reward points: 4436
    • Joined: 2011/04/07 19:51:15
    • Location: Perth WA Australia
    • Status: offline
    Re:garage clean out WA. 2012/04/18 12:44:02 (permalink)
    0
    Having had a think about the underpanels. I won't worry on these anymore, so they are good to goto another home :)

    > P E T E <
    #15
    Page: 12 > Showing page 1 of 2 - Powered by APG vNext Trial
    Jump to:
    © 2025 APG vNext Trial Version 5.5