Go back to home

Matt's AW11 SC

Page: 12 > Showing page 1 of 2 - Powered by APG vNext Trial
Author
MR2JANAI
MR2 Enthusiast
  • Total Posts : 20
  • Scores: 0
  • Reward points: 1449
  • Joined: 2011/04/07 19:51:15
  • Location: Melbourne Vic Australia
  • Status: offline
2007/01/10 02:15:33 (permalink)
0

Matt's AW11 SC

Hey all,
Just a few pics of my 88 AW11 SC. I found when living in Japan last year.
I got it on the road over there and drove it around for about a year. Ive only shipped it to Aust about 6 weeks back. Yet to get it on the road.


This is the week after i picked it up. As you can see 100% stock. It has 110,000kms on it. Very clean car inside and out. Only problem I can find is a sticky throttle cable (fixed with WD40).


First mod was to get European spec cluster with 240km/h speedo. Had an original 7000kms..ish on it.


Second was the HKS pod filter in the boot.


Interior was in great condition but it had an SW gearknob so I swapped it for a White TRD one.


Started to get a little serious with some Works 16" wheels and RS-R springs. Handling was similar but the car dropped about 2 1/2 inches.
Also got rid of the rear spoiler for a while.


Leading up to fitting a larger crank pulley for the supercharger i fitted a boost gauge and dif the bypass mod. Fitted the Nevo pulley soon after. Boost after the mod and after i sorted out the slipping belt was about .8 bar.


Fitted some spats strut braces (actually only put the rear on) but soon after replaced with much thicker sectioned cusco braces front and rear.


Started to get a bit bored with the car for a bit until i found some deep deep dished 8" wide works rims (Pic is taken at toyota-city staduim)



After that i went weekend racing in it. It did very well but its handling was seriously flawed. So i purchased some coilovers from Yahoo auctions.

...and thats basically when i shipped the car back to Australia (coilovers will be installed after its rego'ed)
All I need now is to install a nice quite exhaust to get it on the road in Aust. If anyone have a quiet..ish exhaust to a SC let me know.
I will keep posting as the car changes.

Matt







#1


18 Replies Related Threads

    sandog
    MR2 Enthusiast
    • Total Posts : 232
    • Scores: 2
    • Reward points: 4016
    • Joined: 2011/04/07 19:51:15
    • Location: Melbourne Vic Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/01/10 09:00:51 (permalink)
    0
    sweeet, i like it!
    #2
    RdS
    MR2 Aficionado
    • Total Posts : 501
    • Scores: 15
    • Reward points: 6203
    • Joined: 2011/04/07 19:51:15
    • Location: m e l b o u r n e Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/01/10 12:19:09 (permalink)
    0
    seriously good move starting to mod it over there. most of those parts are just too hard to get here. :(

    looking good though. love the works. :)

    #3

    bustin
    MR2 Aficionado
    • Total Posts : 240
    • Scores: 9
    • Reward points: 2393
    • Joined: 2011/04/07 19:51:15
    • Location: Sth Side Bris, Qld Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/01/10 17:49:31 (permalink)
    0
    Man I love those dished rims. They look damn cool. Keep up the good work.
    #4
    RobYob
    MR2 Aficionado
    • Total Posts : 631
    • Scores: 5
    • Reward points: 1346
    • Joined: 2011/04/07 19:51:15
    • Location: Melbourne Vic Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/01/10 18:55:45 (permalink)
    0
    Noice!!!

    Mr2Janai = Mr2 is not? what the....?

    Wish I'd spent enough time in Jland to buy a car, looks like you're bringing back a sweet Dub. Look forward to seeing it at some vic meets.

    What's your automotive assignment? Toyota, Mitsubishi, Mazda
    #5
    spaniel
    MR2 Enthusiast
    • Total Posts : 207
    • Scores: -4
    • Reward points: 2256
    • Joined: 2011/04/07 19:51:15
    • Location: coffs harbour nsw Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/02/10 20:21:37 (permalink)
    0
    very nice
    gotta love the dish
    #6

    MR2JANAI
    MR2 Enthusiast
    • Total Posts : 20
    • Scores: 0
    • Reward points: 1449
    • Joined: 2011/04/07 19:51:15
    • Location: Melbourne Vic Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/04/10 19:09:19 (permalink)
    0
    Thanks all,
    Now im just looking forward to getting it on the road.
    Getting a new exhaust made up for it on Monday and getting it engineered during the week. Spoke to the engineer today all sounds good....I hope it turns out that way.
    Has anyone had the experience of getting an engineer to look over their AW. I can't think of what they will pick on?
    Then I will try and find a Vic Roads that I can book it into for next friday....then make the most of having my car on the road all next weekend....



    #7
    dsjoyce
    MR2 Enthusiast
    • Total Posts : 22
    • Scores: 0
    • Reward points: 0
    • Joined: 2011/04/07 19:51:15
    • Location: Brisbane Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/04/10 20:24:07 (permalink)
    0
    Sweet car - tell me did you notice any difference going from the (I assume) standard piping and filter to the open filter in the trunk? More induction noise? More power?
    #8
    MR2JANAI
    MR2 Enthusiast
    • Total Posts : 20
    • Scores: 0
    • Reward points: 1449
    • Joined: 2011/04/07 19:51:15
    • Location: Melbourne Vic Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/05/10 12:10:28 (permalink)
    0
    Nah to be honest I noticed no difference. But I think it looks pretty cool. Its too far away and at the back of the car to be able to hear it over the supercharger and exhaust. I also think in regards to the intake the filter isn't the weak link for performance with the supercharged engine. With such a long path from the throttlebody to the head even if you got rid of the filter I dont think you could tell any diff.
    Has anyone else noticed any change by putting a pod filter on a 4AGZE?
    #9
    Koffee-Black
    Vendor
    • Total Posts : 176
    • Scores: 1
    • Reward points: 1978
    • Joined: 2011/04/07 19:51:15
    • Location: Sydney Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/05/10 12:28:56 (permalink)
    0
    I love this car mate!
    #10
    MR2-GZE
    MR2 Enthusiast
    • Total Posts : 17
    • Scores: 2
    • Reward points: 3749
    • Joined: 2011/04/07 19:51:15
    • Location: Beenleigh QLD Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/11/11 21:38:50 (permalink)
    0
    Hey matt love your car, only cause its the same as mine :). I live in Queensland unfortunatley and i would of been more than happy to swap exhaust to help you out if we were closer,seeing my car is all standard and has done around 130,000.

    I still have standard rims too as i am after some wheels and havnt found any wheels in Australia to satisfy my taste. I love those 8 inch deep dish wheels you have and would be willing to do what ever to get a set of those , could you help me :) ??. Any way best of luck with the exhaust. msg me if you can help me with those wheels Cheers Peter . 0410640486.
    http://toyota-mr2.mine.nu/mr2/uploaded/kraze/2007819202313_DSC00243.jpg
    #11
    wasfishing
    MR2 Enthusiast
    • Total Posts : 10
    • Scores: 0
    • Reward points: 1170
    • Joined: 2011/04/07 19:51:15
    • Location: Darwin NT Australia
    • Status: offline
    RE: Matt's AW11 SC 2007/11/14 12:29:25 (permalink)
    0
    I also would love to get a set of those wheels, im in NT so if u can help me out with wheels aswell would be awsome

    cheers Shane
    #12
    MK1corse
    MR2 Aficionado
    • Total Posts : 307
    • Scores: 14
    • Reward points: 5970
    • Joined: 2011/04/07 19:51:15
    • Location: Melbourne, Victoria
    • Status: offline
    RE: Matt's AW11 SC 2011/09/22 16:41:15 (permalink)
    0
    Found ya!!! 
    #13
    dylmrt
    Vendor
    • Total Posts : 2156
    • Scores: 111
    • Reward points: 6118
    • Joined: 2011/04/07 19:51:15
    • Location: NSW Australia
    • Status: offline
    RE: Matt's AW11 SC 2011/09/22 16:53:05 (permalink)
    0


     
    New/used genuine parts for the MR2 community. Send requests through to www.gorillaindustries.com.au/contact
    2002 3SGTE ST246 N-Edition | 1999 3SGTE SW20 GT-S | 1995 3SGTE SW20 GT | 1986 4AGZE AW11 | Join the MR2 Club of NSW http://mr2club.com.au/nsw/
    #14
    scz
    MR2 Scholar
    • Total Posts : 380
    • Scores: 18
    • Reward points: 4035
    • Joined: 2011/04/07 19:51:15
    • Location: Merewether, NSW Australia
    • Status: offline
    RE: Matt's AW11 SC 2011/09/24 15:59:07 (permalink)
    0
    My SC had the same HKS pod when it was imported. May I suggest replacing it with a K & N unit? I have heard of a few occasions wher the foam has been sucked down the intake with disastrous results. Especially with the upgraded supercharger pulley making it suck that bit harder.
    #15
    Page: 12 > Showing page 1 of 2 - Powered by APG vNext Trial
    Jump to:
    © 2025 APG vNext Trial Version 5.5