Go back to home

Heaps of MR2 SW20 Parts.

Page: 1234 > Showing page 1 of 4 - Powered by APG vNext Trial
Author
mrmr2
Supporter
  • Total Posts : 338
  • Scores: 5
  • Reward points: 6622
  • Joined: 2011/04/07 19:51:15
  • Location: Australia
  • Status: offline
2011/07/16 00:14:13 (permalink)
0

Heaps of MR2 SW20 Parts.














 


 
 




 





 
All these parts are for sale + more, here is a list.
1) ABS computer $80
2)
Engine Bay Fuse Box $45
3)
Charcoal Canister $40
4) One indicator $20
5)
Horn $15
6) GT Badges Black (needs painting) $10 Silver (Excellent Condition) $15
7) Fuel Pump Injector Resistor Packs and fuel pump relay  $50
8) Fog Lamp Controller computer $30
9) Plastic Arch Liners $50 per side or $100 for pair.
10) Plastic gear surround $50
11)
Clutch, Accelerator and Brake Pedals
12) The two Engine support/Brace bars
13)
Rear lower control Arms
14) Genuine HKS
air filter adapter plate
15)
Various size silicon couplers
16)
1x OEM door speaker
17) 1x Sony speaker
18)
Stock plastic sub-woofer cover for on the floor near the storage compartment
19) Washer Bottle
20)
Air Ducting
21)
Intercooler
22)
Intercooler Fan
23)
Power Steering Fluid Container with pipe
24) Fuel door release cable
25) Fuel door $10
26) Fully adjustable steering column
27) Climate control unit
28) Boot Hindges

29) Air flow meter (unknown condition) $50
30) Gold anodized Valve cover to throttle body bracket
31) Pair of headlight set-ups with motors included
32) Engine mounts
33) Front Bonnet Stand
34) Valve cover bolts
35) Front Suspension tops

36) Dash light dimmer switch
37) Red leather boot modified for MR2
38) Various Brackets and shields including CAT shields
39) Bottom of ash tray

40) Heater Units
41) Hand Brake cables ( I believe)

42) Boot cable and catch mechanism
43) Custom made Flat panel for GEN 1 taillights (not round ones)
44) Air intake duct
45) Graphite heat wrap keep intake temperatures down ( Same as used on my car some has been used some has not) $8 per meter
46) US Audio sub box, 12" $25
47) H3 Opti blue (bright white) XEON gas filled globes for fog lights, Brand New, $20
48) 3SGTE Engine stand, custom made for dropping the engine strait out from under the car $120
49) Various coolant/heater/brake/air-con piping
50) Rear Cross member
Unpictured Items:
Master Cylinder & Push-rod $45
Door Lock Mechanism and door handle $40
Turbo oil drain pipe
OEM Oil Cap
OEM radiator cap
OEM oxygen sensor
OEM Plastic trip for around roof ordered from toyota japan brand new
OEM Dump pipe Turbo outlet pipe to sump rubber connector hose
New distributor bearing
Full set of Original wheels with near near tyres off a 1990 Turbo SW20
Original metal front fenders in perfect condition
Number plate lights
1990 SW20 Turbo axles
Low K's Turbo Toyota Alternator
Perfect catalytic convertor and dump pipe setup with temp sensor included.
Low K's Air Conditioner Compressor


post edited by mrmr2 - 2011/07/31 23:02:33
#1


56 Replies Related Threads

    Soaren1
    MR2 Aficionado
    • Total Posts : 415
    • Scores: 10
    • Reward points: 4567
    • Joined: 2011/04/07 19:51:15
    • Location: Perth WA Australia
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/16 03:27:59 (permalink)
    0
    hey mate, ill take the indicator if it is passenger side? PM me. Thanks
    #2
    brendan1990
    MR2 Enthusiast
    • Total Posts : 46
    • Scores: 0
    • Reward points: 152
    • Joined: 2011/06/29 20:17:29
    • Location: Narre Warren South
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/16 13:03:50 (permalink)
    0
    pm sent
    #3

    mrmr2
    Supporter
    • Total Posts : 338
    • Scores: 5
    • Reward points: 6622
    • Joined: 2011/04/07 19:51:15
    • Location: Australia
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/16 20:37:22 (permalink)
    0
    PM's Sent
    #4
    madd
    MR2 Enthusiast
    • Total Posts : 1
    • Scores: 0
    • Reward points: 46
    • Joined: 2011/06/17 11:50:08
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/16 22:36:10 (permalink)
    0
    could you put up some pics of the custom 3sgte engine stand please and also a price if possible
     
    thx
    #5
    Shamanova
    MR2 Enthusiast
    • Total Posts : 225
    • Scores: 2
    • Reward points: 2163
    • Joined: 2011/04/07 19:51:15
    • Location: Brisbane Queensland Australia
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/16 22:54:55 (permalink)
    0
    Hey mate after the plastic part that connects the fan with the rest of the piping in the centre console. its the unit that's below the glove box just above where the passengers feet rest. Is that the part in the photo next to the fan unit?
    #6

    Soaren1
    MR2 Aficionado
    • Total Posts : 415
    • Scores: 10
    • Reward points: 4567
    • Joined: 2011/04/07 19:51:15
    • Location: Perth WA Australia
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/16 23:41:40 (permalink)
    0
    Damn mate was really hoping for passenger side. Ill have to pass thanks
    #7
    asimovy
    MR2 Aficionado
    • Total Posts : 101
    • Scores: 7
    • Reward points: 2800
    • Joined: 2011/04/07 19:51:15
    • Location: sydney
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/16 23:43:06 (permalink)
    0
    I'm after the front and rear engine mounts, there off an NA sw20 right? Any serious wear to them?
    How much for postage to 2075 nsw?


     
    #8
    mrmr2
    Supporter
    • Total Posts : 338
    • Scores: 5
    • Reward points: 6622
    • Joined: 2011/04/07 19:51:15
    • Location: Australia
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/17 00:44:42 (permalink)
    0
    Madd: Pm'd - photo added

    Shamanova: Can you please elaborate a little more please mate I'm trying to think of the vent your referring too, I can't remember venting near the center console maybe somebody can help confirm this part for us?

    Soaren1: No worries mate.

    Asimovy: I have 3 out of 4 mounts they are out of a Turbo model MR2 I'm not sure if they are compatible with your N/A MR2?
    #9
    Shamanova
    MR2 Enthusiast
    • Total Posts : 225
    • Scores: 2
    • Reward points: 2163
    • Joined: 2011/04/07 19:51:15
    • Location: Brisbane Queensland Australia
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/17 09:06:31 (permalink)
    0
    Yeah I'm pretty useless at describing things by their real names so to help out please see the photo below:

     
    I believe aircon pipe from the frunk also feeds into this unit. But yeah it's located under the glove box above the passengers feet.
    #10
    ijanders
    MR2 Enthusiast
    • Total Posts : 2
    • Scores: 0
    • Reward points: 234
    • Joined: 2011/05/14 16:43:40
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/17 11:57:14 (permalink)
    0
    Where are you located?
    #11
    Sas
    MR2 Enthusiast
    • Total Posts : 31
    • Scores: -4
    • Reward points: 916
    • Joined: 2011/04/07 19:51:15
    • Location: Sydney NSW Australia
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/17 14:54:07 (permalink)
    0
    pm'd.

    1991 N/A Black SW20
    #12
    jpaudio
    MR2 Scholar
    • Total Posts : 520
    • Scores: 16
    • Reward points: 3165
    • Joined: 2011/04/07 19:51:15
    • Location: Sydney nsw Australia
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/17 17:17:35 (permalink)
    0
    ijanders

    Where are you located?

     
    +1
    #13
    Dudeman
    Supporter
    • Total Posts : 2589
    • Scores: 259
    • Reward points: 6112
    • Joined: 2011/04/07 19:51:15
    • Location: Dark side of the moon.
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/17 18:26:18 (permalink)
    0
    Pretty sure he's in Vic somewhere...

    .
    .
     
           
    #14
    mrmr2
    Supporter
    • Total Posts : 338
    • Scores: 5
    • Reward points: 6622
    • Joined: 2011/04/07 19:51:15
    • Location: Australia
    • Status: offline
    Re:Heaps of MR2 SW20 Parts. 2011/07/17 21:22:13 (permalink)
    0
    Jpaudio, Yes I'm from Victoria I will be in Melbourne on the 21st and 22nd of July if you wanted to meet but I'm happy to post anything, what part/parts were you chasing?
    Shamanova, I should know were this piece of venting goes I only pulled my whole dash out! I'm thinking it's the piece that goes behind the 2 front vents in the middle, I'll upload another pic in a sec which will hopefully help identify it.
    Sas: Pm'd back.
    Dudeman: Thanks
    #15
    Page: 1234 > Showing page 1 of 4 - Powered by APG vNext Trial
    Jump to:
    © 2025 APG vNext Trial Version 5.5