Mega Squirt PnP 2 ECU

For 4AGE engine. Plug and Play. Uses oem plugs and can be used to eliminate the problematic air flow meter..
Easy to Use and Install!

- Fully Plug and Play Installation - No wiring required for basic functionality. Average install time is under 1 hour!
- Real time tuning and data logging with a laptop connection
- Supports most aftermarket wideband sensors

Fully Tunable Engine Control!

- 16x16 Fuel Tables allow high resolution tuning
- 12x12 Ignition Tables
- Multiple Acceleration enrichment strategies
- Closed Loop Idle Speed Control
- Air Conditioner Control
- Up to 4 sequential fuel injector channels with individual trim tables (minor wiring change required to run sequential, 4AGE only)
- Onboard peak and hold drivers support both high and low impedance injectors - No external ballast resistor is needed!
- Allows removal of stock airflow meter

Advanced Feature Set (Included!)

- 12x12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
- Built-in 2-step rev limiter / launch control with flat shift
- Real time barometric correction
- Internal 4-bar MAP sensor reads up to 44PSI of boost
- Overboost protection
- Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit)
- Knock sensor input with adjustable sensitivity
- Headphone output for knock sensor - listen for knock while you tune!
- Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
- Input for flex fuel sensor - switch between E85 and gasoline on the fly!
- CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors.....the possibilities are limitless!

$500.00

Located in Brisbane.