Go back to home

Kojab's 1992 GT Hardtop Project

Page: < 12 Showing page 2 of 2 - Powered by APG vNext Trial
Author
Post
Essentials Only Full Version
kojab
MR2 Deity
  • Total Posts : 235
  • Scores: 40
  • Reward points: 3666
  • Joined: 2012/02/28 11:44:25
  • Location: Sydney/Sutherland Shire
  • Status: offline
Re: Kojab's 1993 GT Hardtop Project 2019/04/16 09:19:31 (permalink)
+1 (1)

 
Engine is in and running. Just finished installing Border A2A Intercooler
 and was very impressed with it's ability to to cool the boosted air.

Before fitting the Border (no intercooler) 10 PSI of boost was producing 68 degC of air
temperature.
Now with Border and the same 10 PSI the air temp does not increase, infact it actually
drops a deg. Big test will be when I up the boost to some where around 25 PSI.

Only just started tuning the new engine so have got along way to go.

If anyone is interested I will put some collected data/logs up.
 
 

92' SW20 3SGTE   GEN2 GT Hardtop Holden Ls1 ECU
87' AW11 3SGTE   Delco EFI ECU & 21 psi boost
71' KE25 3TGTE    Delco EFI ECU Standard engine 24 psi boost
78' KE55 L67        Delco EFI ECU
#16
kojab
MR2 Deity
  • Total Posts : 235
  • Scores: 40
  • Reward points: 3666
  • Joined: 2012/02/28 11:44:25
  • Location: Sydney/Sutherland Shire
  • Status: offline
Re: Kojab's 1993 GT Hardtop Project 2020/09/21 15:06:05 (permalink)
0
Just installed a 2 DIN Android stereo head unit and discovered the electric antenna does not work. Traced the wiring back to RAD & CIG Fuse 15 Amp.  Fuse was fine but no 12 Volts present at this fuse holder.
 
Then I noticed this white empty socket below the fuses. 
 
 
 
Is this normal for a JDM 92 GT Hardtop?  The missing fuse in this picture is the RAD & CIG Fuse which along with other voltages feeds the electric antenna.

92' SW20 3SGTE   GEN2 GT Hardtop Holden Ls1 ECU
87' AW11 3SGTE   Delco EFI ECU & 21 psi boost
71' KE25 3TGTE    Delco EFI ECU Standard engine 24 psi boost
78' KE55 L67        Delco EFI ECU
#17
PocketRadzys
MR2 Aficionado
  • Total Posts : 41
  • Scores: 15
  • Reward points: 1911
  • Joined: 2020/04/17 03:09:28
  • Location: Adelaide, SA
  • Status: offline
Re: Kojab's 1993 GT Hardtop Project 2020/09/21 17:09:58 (permalink)
0
Hard to tell 100% without taking off the plastic trim but on my car it feels like there is a similar long rectangular socket with nothing plugged in in that same spot. Mine's a JDM 90 GT hardtop.
#18

twomr2`s
Supporter
  • Total Posts : 176
  • Scores: 46
  • Reward points: 5893
  • Joined: 2012/01/25 01:53:29
  • Location: hillarys,WA
  • Status: offline
Re: Kojab's 1993 GT Hardtop Project 2020/09/21 18:32:50 (permalink)
+1 (1)
cruise control,theft deterrent ecu and the rh rear abs sensor are all on that plug.
if your car has or had the premium sound system with the 2 amps on the back left hand side then the antenna feed at the dash doesnt usually work,ive got mine to work by jumping the green/black wire to the pink/blue at the antenna plug in the boot

find me on gumtree here https://www.gumtree.com.au/s-ad/hillarys/engine-engine-parts-transmission/mr2-sw20-parts-3sgte-and-3sge-updated-weekly/1281335059
#19
kojab
MR2 Deity
  • Total Posts : 235
  • Scores: 40
  • Reward points: 3666
  • Joined: 2012/02/28 11:44:25
  • Location: Sydney/Sutherland Shire
  • Status: offline
Re: Kojab's 1993 GT Hardtop Project 2020/09/22 11:55:18 (permalink)
0
Thank you twomr2's your post was very helpful.  Explains the the empty socket and with regards "jumping the green/black wire to the pink/blue at the antenna plug" 
Under the dash I joined Pin1 pink/blue and Pin7 Black/red along with the blue Ant wire from the Andriod Head unit.
Antenna now works fine.
 
Thanks again

92' SW20 3SGTE   GEN2 GT Hardtop Holden Ls1 ECU
87' AW11 3SGTE   Delco EFI ECU & 21 psi boost
71' KE25 3TGTE    Delco EFI ECU Standard engine 24 psi boost
78' KE55 L67        Delco EFI ECU
#20
Page: < 12 Showing page 2 of 2 - Powered by APG vNext Trial
Jump to:
© 2025 APG vNext Trial Version 5.5