Go back to home

Question with regards clutch tool alignment

Author
Post
Essentials Only Full Version
kojab
MR2 Deity
  • Total Posts : 235
  • Scores: 40
  • Reward points: 3666
  • Joined: 2012/02/28 11:44:25
  • Location: Sydney/Sutherland Shire
  • Status: offline
2017/12/02 10:20:35 (permalink)
0

Question with regards clutch tool alignment

I am preparing to fit a new HD Exedy clutch assy in my SW20.  The plastic Exedy alignment tools described on Ebay show spigot size as 11.9mm.  My Gen2 engine's crankshaft has a hole approx 24.5mm dia at the rear (flywheel end) where there is no spigot bearing fitted.  I understand a spigot bearing is not required for the gearbox I am using. Do I have to fit a spigot bearing just to use the Ebay alignment tool?  Does not seem right to me.  What am I missing?

92' SW20 3SGTE   GEN2 GT Hardtop Holden Ls1 ECU
87' AW11 3SGTE   Delco EFI ECU & 21 psi boost
71' KE25 3TGTE    Delco EFI ECU Standard engine 24 psi boost
78' KE55 L67        Delco EFI ECU
#1


2 Replies Related Threads
    Carmikey
    MR2 Deity
    • Total Posts : 1969
    • Scores: 260
    • Reward points: 6437
    • Joined: 2012/04/23 15:31:23
    • Location: Greenwith 5125, S.A. Australia
    • Status: offline
    Re: Question with regards clutch tool alignment 2017/12/02 10:56:35 (permalink)
    0
    No spigot bearing, ignore what the listing states. They fit fine.

    Sent from my SM-J320ZN using Tapatalk

    #2
    kojab
    MR2 Deity
    • Total Posts : 235
    • Scores: 40
    • Reward points: 3666
    • Joined: 2012/02/28 11:44:25
    • Location: Sydney/Sutherland Shire
    • Status: offline
    Re: Question with regards clutch tool alignment 2017/12/02 11:02:02 (permalink)
    0
    Thanks I will order the Ebay alignment tool.

    92' SW20 3SGTE   GEN2 GT Hardtop Holden Ls1 ECU
    87' AW11 3SGTE   Delco EFI ECU & 21 psi boost
    71' KE25 3TGTE    Delco EFI ECU Standard engine 24 psi boost
    78' KE55 L67        Delco EFI ECU
    #3

    Jump to:
    © 2025 APG vNext Trial Version 5.5