Go back to home

Potential MR2 buyer: questions!

Author
alexv
MR2 Enthusiast
  • Total Posts : 136
  • Scores: 4
  • Reward points: 1106
  • Joined: 2013/11/04 10:06:33
  • Location: Canberra, ACT
  • Status: offline
2013/11/04 10:20:48 (permalink)
0

Potential MR2 buyer: questions!

Hi, I am coming back to Australia (ACT) after living in the US for a bit and I am looking at buying a MR2 MKII turbo (most likely rev3+). From what I have seen so far, they are 'fairly' cheap to maintain except for the timing belt replacement which seems like a very complex task. I haven't been able to find any cost estimate on that one so far though? What kind of cost am I am looking at here?
Also is there any important difference between ADM and JDM import MR2 (eg: insurance being more expensive??)?
 
This looks like a very fun car to drive :)
Thanks!
-Alex
 
post edited by alexv - 2013/11/04 11:35:14
#1


12 Replies Related Threads

    Dudeman
    Supporter
    • Total Posts : 2589
    • Scores: 259
    • Reward points: 6112
    • Joined: 2011/04/07 19:51:15
    • Location: Dark side of the moon.
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/11/04 10:49:31 (permalink)
    0
    Not so many turbo SW rev3+ around ('Gen' refers to 'Gen1 AW', 'Gen2 SW', 'Gen3 ZZ' (Generation)) SW had rev1,2,3,4,5 (Revisions). Please correct if i'm wrong again...
     
    I have a rev1 turbo import and a rev3 ADM non turbo. Insurance cost is the same for me (oldish fart) but some insurers refuse the import, I went with Shannons for it.
     
    I get the timing belts done by Toyota at Camden NSW, can't remember the exact figure but it wasn't too bad, less than $400 with full service I think. 

    .
    .
     
           
    #2
    alexv
    MR2 Enthusiast
    • Total Posts : 136
    • Scores: 4
    • Reward points: 1106
    • Joined: 2013/11/04 10:06:33
    • Location: Canberra, ACT
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/11/04 11:34:09 (permalink)
    0
    Cool, that seems a lot cheaper than expected, everyone seems to say that it's super complicated to fix/ replace so I was expecting at least $1000+ (parts + labor)
     
    And yeah, I meant gen2 rev3+, my bad :)
    #3

    dylmrt
    Vendor
    • Total Posts : 2156
    • Scores: 111
    • Reward points: 6118
    • Joined: 2011/04/07 19:51:15
    • Location: NSW Australia
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/11/04 11:40:03 (permalink)
    +1 (1)
    $400 is a bargain Dudeman. I might have to take my car down your way the next time I need that done! I'd say you're more likely to find places want $1000 for the job than $400.

     
    New/used genuine parts for the MR2 community. Send requests through to www.gorillaindustries.com.au/contact
    2002 3SGTE ST246 N-Edition | 1999 3SGTE SW20 GT-S | 1995 3SGTE SW20 GT | 1986 4AGZE AW11 | Join the MR2 Club of NSW http://mr2club.com.au/nsw/
    #4
    Dudeman
    Supporter
    • Total Posts : 2589
    • Scores: 259
    • Reward points: 6112
    • Joined: 2011/04/07 19:51:15
    • Location: Dark side of the moon.
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/11/04 12:01:05 (permalink)
    0
    dylmrt
    $400 is a bargain Dudeman. I might have to take my car down your way the next time I need that done! I'd say you're more likely to find places want $1000 for the job than $400.




    I was prepared to take that sort of sting there but it didn't happen. 
     
    Best to always call ahead with the job for an estimate though. It's a really good workshop, make sure you take it to the Camden workshop not the Narellen one. The latter insisted that my funked out rear bearing was 'only tyre noise'

    .
    .
     
           
    #5
    alexv
    MR2 Enthusiast
    • Total Posts : 136
    • Scores: 4
    • Reward points: 1106
    • Joined: 2013/11/04 10:06:33
    • Location: Canberra, ACT
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/11/04 12:09:35 (permalink)
    0
    Actually Dudeman, a question for you since you have driven both the turbo and non-turbo: do you feel the lack of turbo while driving the non-turbo MR2, or not really?
    I have seen some sweet non-turbo MR2 around, but I feel like I may end up regretting not getting the turbo'd one.
    But then again, I am currently driving a 96 Mustang Cobra and I can never really step on it as it gets up to the legal speed very quickly making me feel like I don't really need the extra power (but the exhaust sounds wonderful)...
    #6

    Reddtarga
    MR2 Deity
    • Total Posts : 2175
    • Scores: 249
    • Reward points: 5547
    • Joined: 2011/04/07 19:51:15
    • Location: Vic Australia
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/11/04 17:38:09 (permalink)
    0
    Timing belt replacement.
    Dudeman, what exactly did you get for $400?
     
    To do the job properly many people also recommend changing other stuff at the same time, including:
    Quality HSN belt 
    New tensioner 
    New genuine Toyota full water pump
    New belt rollers 
    Cam seals etc.
    That's perhaps a total of $400+ for parts alone.
     
     

    1990 ADM NA
     
     
     
     
     
     
    #7
    Dudeman
    Supporter
    • Total Posts : 2589
    • Scores: 259
    • Reward points: 6112
    • Joined: 2011/04/07 19:51:15
    • Location: Dark side of the moon.
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/11/05 08:30:49 (permalink)
    +1 (1)
    alexv
    Actually Dudeman, a question for you since you have driven both the turbo and non-turbo: do you feel the lack of turbo while driving the non-turbo MR2, or not really?
    I have seen some sweet non-turbo MR2 around, but I feel like I may end up regretting not getting the turbo'd one.
    But then again, I am currently driving a 96 Mustang Cobra and I can never really step on it as it gets up to the legal speed very quickly making me feel like I don't really need the extra power (but the exhaust sounds wonderful)...


     
    The n/a is a very nice car and is cool to drive, i've had a lot of enjoyment out of it, but the basic answer is that they are totally different cars power wise.
    From a standing start the turbo is good thumping acceleration fun, tight bends on uphills you can give the n/a just about 100% (not through the corner...) and it gets up there - the turbo needs more care.
     
    I used the n/a as a commuter for nearly eight years, the turbo is now the preferred car for fun.

    Reddtarga
    Timing belt replacement.
    Dudeman, what exactly did you get for $400?
     
    To do the job properly many people also recommend changing other stuff at the same time, including:
    Quality HSN belt 
    New tensioner 
    New genuine Toyota full water pump
    New belt rollers 
    Cam seals etc.
    That's perhaps a total of $400+ for parts alone.
     

     
    Toyota timing belt, major service, none of the other parts you mentioned.
    Done at 100,000 and 200,000. 
    Touch wood - 275,000 k's no dramas.
     
    That's for the n/a. Haven't had timing belt done on the turbo, but Camden Toyota were happy to service it as well.



    post edited by Dudeman - 2013/11/05 08:33:50

    .
    .
     
           
    #8
    Carmikey
    MR2 Deity
    • Total Posts : 1969
    • Scores: 260
    • Reward points: 6437
    • Joined: 2012/04/23 15:31:23
    • Location: Greenwith 5125, S.A. Australia
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/11/05 08:52:56 (permalink)
    +1 (1)
    alexv
    Actually Dudeman, a question for you since you have driven both the turbo and non-turbo: do you feel the lack of turbo while driving the non-turbo MR2, or not really?
    I have seen some sweet non-turbo MR2 around, but I feel like I may end up regretting not getting the turbo'd one.
    But then again, I am currently driving a 96 Mustang Cobra and I can never really step on it as it gets up to the legal speed very quickly making me feel like I don't really need the extra power (but the exhaust sounds wonderful)...


    ^^Alexv, Hi I too have drive a few NA's & a lot like Dudeman, once you have been in a turbo mr2 it ant long before the need is there to purchase & own one.  If you haven't yet picked it up - the turbo is also my preferred car all round.
     
    Many people go down the path of thinking a NA will be suffice, but I would say at least 90% of them end up (may be years later) but never the less converting to a turbo engine or buying a genuine turbo mr2.
    The good out of any of this - is you by the sounds of things will be in an Mr2 shortly & that's all that matters.
     
    Good luck with your hopefully upcoming purchase & hope to see you in an mr2 in the near future.
    #9
    dylmrt
    Vendor
    • Total Posts : 2156
    • Scores: 111
    • Reward points: 6118
    • Joined: 2011/04/07 19:51:15
    • Location: NSW Australia
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/12/04 18:10:03 (permalink)
    0
    I have to say its different fun with an NA vs a Turbo.
     
    The AW11 NA i can drive really hard and you get the enjoyment from really taking the car to its limits (thrashing it all the way to 3rd gear and its still under 80km/h lol)
     
    The tubby is an entirely different feeling. On the street, you just can't use its full potential without falling a fair way foul of the law. On a track however, there's no comparison.

     
    New/used genuine parts for the MR2 community. Send requests through to www.gorillaindustries.com.au/contact
    2002 3SGTE ST246 N-Edition | 1999 3SGTE SW20 GT-S | 1995 3SGTE SW20 GT | 1986 4AGZE AW11 | Join the MR2 Club of NSW http://mr2club.com.au/nsw/
    #10
    MR2QIK
    MR2 Deity
    • Total Posts : 2015
    • Scores: 106
    • Reward points: 3479
    • Joined: 2011/04/07 19:51:15
    • Location: Sydney NSW Australia
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/12/04 19:47:06 (permalink)
    0
    Maintenance is consistent with its age. Get a turbo for sure if you can. A nice sorted example would prolly have the timing belt done already so I doubt that's going to be required.

    MR2QIK - "The Little Car That Could"



    320rwkw @ 19psi (pump fuel, no giggle gas)
    11.96 @ 116mph (with 228rwkw)
    #11
    alexv
    MR2 Enthusiast
    • Total Posts : 136
    • Scores: 4
    • Reward points: 1106
    • Joined: 2013/11/04 10:06:33
    • Location: Canberra, ACT
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/12/05 09:28:30 (permalink)
    +1 (1)
    Yep, so I ended up buying a 91 turbo from a member here from SA
    Already thinking of doing a few upgrades :)
    #12
    MR2QIK
    MR2 Deity
    • Total Posts : 2015
    • Scores: 106
    • Reward points: 3479
    • Joined: 2011/04/07 19:51:15
    • Location: Sydney NSW Australia
    • Status: offline
    Re: Potential MR2 buyer: questions! 2013/12/05 10:58:01 (permalink)
    0
    That was fast. Members ride thread.

    MR2QIK - "The Little Car That Could"



    320rwkw @ 19psi (pump fuel, no giggle gas)
    11.96 @ 116mph (with 228rwkw)
    #13
    Jump to:
    © 2025 APG vNext Trial Version 5.5