2lateforPplate

I would like a new door tyre specs decal. Are they available for sale ?

Contact Joel on this forum, I'm sure he will be able to assist.

Sent from my SM-J320ZN using Tapatalk

A very big thankyou to carmikey for putting me up for the morning and showing me some of the wonderful driving roads around Adelaide.

The car is an absolute dream to drive.

rynex
A very big thankyou to carmikey for putting me up for the morning and showing me some of the wonderful driving roads around Adelaide.

The car is an absolute dream to drive.

 
 
It was super cool... was great to meet & share the mr2 experience with another like minded enthusiast. Here are the pics you took on the day parked on the famous Gorge Rd.
 


 

Looks great in the sun!

Little more progress on the mr2
 
Original front rotors seemed ok & stable up until around the 80kms + mark, then shudder like mad under braking


 
New QFM A1RMs front pads

 
New Slotted rotors

 
New rotors & pads installed

 

 
 
Whilst at it, the new rear wheel bearings finally arrived, installed & drives like new now.

How difficult is it to change the rear wheel bearings?  I have a noise in the back of my AW11 which I am trying to diagnose.  Its worse when the car is cold and also bad when making a right hand turn.  After about 4 to 5 kilometers it seems to not be so noticeable. 
 
Also thanks again for the Air conditioning parts for my SW20.

kojab
How difficult is it to change the rear wheel bearings? 
 
Also thanks again for the Air conditioning parts for my SW20.

The rear wheel bearings can be a little tricky, using a press, as always the hardest part is to ensure the bearing is totally square when pressing in. The outer seals were probably the hardest to remove, although if buying a wheel bearing kit, new seals come with it, so damaging the original ones is not an issue. I took extra care when removing them just in case I had to re-use them. But yes I would suggest your bearings require replacement.

Make sure the slides on the calipers aren't seized and slide back and forth reasonably smoothly.   Also use a torque wrench to do up wheel nuts, most common cause or warped rotors is uneven wheel nut torques.   76ftlb is the aw11 wheel nut torque.   
 
 

Sad to see this beautiful little car go! It's has been sold to a very lucky enthusiastic forum member. Fantastic guy too, which made the sale that tiny bit easier. Good Luck with the car Ry.

Sent from my SM-J320ZN using Tapatalk

I cannot wait to get it here and get cracking :)

Sent from my Realme X using Tapatalk