Go back to home

Power FC help

Author
Post
Essentials Only Full Version
Blue2
MR2 Aficionado
  • Total Posts : 252
  • Scores: 6
  • Reward points: 3844
  • Joined: 2011/04/07 19:51:15
  • Status: offline
2013/06/28 20:08:07 (permalink)
0

Power FC help

Does anyone know, what the IDLE sensor in power FC refers to?

I looked in my sensors screen which shows what's on and off, voltage etc. And the idle is off.

Anyone know what it is referring to?
#1


5 Replies Related Threads
    robk
    MR2 Deity
    • Total Posts : 2172
    • Scores: 314
    • Reward points: 5229
    • Joined: 2011/04/07 19:51:15
    • Location: Sydney / Central Coast, NSW Australia
    • Status: offline
    Re: Power FC help 2013/06/28 20:20:47 (permalink)
    0
    I'm guessing that it's for the closed-throttle switch.

    There is an extensive build thread for my car here: http://www.mr2australia.com/mr2play/tm.aspx?m=18316
    #2
    Blue2
    MR2 Aficionado
    • Total Posts : 252
    • Scores: 6
    • Reward points: 3844
    • Joined: 2011/04/07 19:51:15
    • Status: offline
    Re: Power FC help 2013/06/28 20:25:22 (permalink)
    0
    Hmm car idles at 950 to 1000 even though we are telling it to idle at 800.
    But sensor is showing off. Do u know where this switch s located?
    #3

    robk
    MR2 Deity
    • Total Posts : 2172
    • Scores: 314
    • Reward points: 5229
    • Joined: 2011/04/07 19:51:15
    • Location: Sydney / Central Coast, NSW Australia
    • Status: offline
    Re: Power FC help 2013/06/28 20:53:05 (permalink)
    0
    The closed throttle switch is part of the TPS, which is why the TPS has 4 wires instead of 3 like a normal TPS. 
    If the 'IDLE' value does correspond to the closed throttle switch, it should toggle on/off when you move the throttle from fully closed to slightly open and back again.
     

    There is an extensive build thread for my car here: http://www.mr2australia.com/mr2play/tm.aspx?m=18316
    #4
    Mrskylighter
    MR2 Deity
    • Total Posts : 2156
    • Scores: 174
    • Reward points: 6592
    • Joined: 2011/04/07 19:51:15
    • Location: NSW Australia, Hills District
    • Status: offline
    Re: Power FC help 2013/06/28 21:54:16 (permalink)
    0
    Sounds like you might need to adjust your TPS back to spec.
    #5
    Blue2
    MR2 Aficionado
    • Total Posts : 252
    • Scores: 6
    • Reward points: 3844
    • Joined: 2011/04/07 19:51:15
    • Status: offline
    Re: Power FC help 2013/06/29 04:42:06 (permalink)
    0
    ill give it a go.
    #6

    Jump to:
    © 2025 APG vNext Trial Version 5.5