Go back to home

3SGTE exhaust manifold on 3SGE (gen 2)

Page: < 12 Showing page 2 of 2 - Powered by APG vNext Trial
Author
Post
Essentials Only Full Version
MR2QIK
MR2 Deity
  • Total Posts : 2015
  • Scores: 106
  • Reward points: 3479
  • Joined: 2011/04/07 19:51:15
  • Location: Sydney NSW Australia
  • Status: offline
Re: 3SGTE exhaust manifold on 3SGE (gen 2) 2014/01/21 15:59:00 (permalink)
0
I assume they're the same headers used on the 220hp Toms To22 NA MR2. If so, it'd be a good upgrade.

MR2QIK - "The Little Car That Could"



320rwkw @ 19psi (pump fuel, no giggle gas)
11.96 @ 116mph (with 228rwkw)
#16
Gatesys SW20
Supporter
  • Total Posts : 1106
  • Scores: 22
  • Reward points: 1110
  • Joined: 2012/11/06 19:28:18
  • Status: offline
Re: 3SGTE exhaust manifold on 3SGE (gen 2) 2014/01/21 17:40:26 (permalink)
0
Hmm, might buy them.. ahaha :) thanks Man!
#17
Senor_2
MR2 Deity
  • Total Posts : 600
  • Scores: 74
  • Reward points: 4558
  • Joined: 2011/04/07 19:51:15
  • Location: Sydney NSW Australia
  • Status: offline
Re: 3SGTE exhaust manifold on 3SGE (gen 2) 2014/01/21 22:41:41 (permalink)
+1 (1)
Gatesys SW20
Bit of a hijack, but I heard the JASMA (toms) Gen 2 headers Stainless are quite a good upgrade?
Anyone to confirm or thoughts on this?


FYI, JASMA isn't a brand, it's the Japanese Automobile Sport Muffler Association, so if an exhaust component has a JASMA certification it just means it would pass inspection in Japan
As MR2QIK said, Tom's products are generally very good, they're a factory backed company so would likely be a nice upgrade

A man in Dandism
==========================
SW20 Midship Runabout
#18

Page: < 12 Showing page 2 of 2 - Powered by APG vNext Trial
Jump to:
© 2025 APG vNext Trial Version 5.5