ATS 6 puck unsprung & lightened flywheel problem
I have just finished putting a ats 6puck unsprung clutch in and a light weight flywheel, i have a problem where the clutch will not disengage.
I know i installed everything correctly, 99% sure because i triple check everything.
With the engine off i can cycle through all gears,
With the engine on i cannot select a gear,
I can start the car in gear and it takes off.
Does anyone know if you have to adjust the pivot under the release fork?
I used the throwout bearing that was supplied with the clutch kit, the clutch plate is around the right way.
The flywheel in a 2nd hand though machined chromoly lightened flyweel purchase from road and track
there is a little squeak when i push the clutch pedal (noise comes from engine bay, i can see and feel the slave piston push the fork. The slave has no play in it and is installed correctly.
I am going to try and adjust the pedal tomorrow but if not i guess i have to pull the gearbox.
any ideas anyone?
Cheers.