SOLD - Melb: Engine lid shroud with 2 SPAL 12" fans
SOLD 'Totenkopf' SW20 MR2 engine lid shroud with fans Aluminium engine lid fan shroud (Not steel like earlier ones made) powder coated BLACK
Comes with 2x 12" SPAL fans. Fans have Deutsch DT connectors, i can supply matching connectors for free.
The shroud has light scratches here and there, however looks good from few meters back, no big scrapes or dints.
The holes in the top corners were the rubber stoppers screws in have been drilled out as i had bonnet pins in that location, bit of a hack job as i never got around to neatening it up, so would suit buyer that wants to put bonnet pins on there lid (race car, if engine on fire, doubt any track marshals would know were pull cable is, thats if the drivers door can even open!) or a small thin plate can i guess be made with a hole for the rubber stopper to push into, and then riveted onto shroud.
Also has 3 holes drilled on the left hand side near the bottom (1 10c piece size and 2 tiny holes next to it) which was for a electrical connector)
Never actually had engine running when this was on the car, so no heat ect and the fans have only been tested with a battery 2 or 3 times.
SOLD Item Location: Ringwood, Victoria
Shipping / Payments: Pickup preferred or can post at buyers cost. Payment can be Cash (if pickup), bank deposit or paypal.
post edited by WIDEMR - 2013/02/12 21:29:25