*FS Liverpool* AW11 Parts

Pm me or call Joel 0410302495
 
MR2 AW11 NA 4AGE tail light set - A tail light and garnish set from a 1987 toyota AW11 with 4AGE. The centre garnish was painted red to match the car.
All in good nick with all mountings except for 1 of the plastic clips in the bottom centre of the garnish. And the rh tail light has a small bit of white overspray paint. Will need a clean. $50
 
 
MR2 AW11 popup head lights. Rh and Lh complete - A pair of standard pop up headlights from a Toyota Mr2 1987 AW11.
In good working order. A few paint chips on the front of the covers. Missing manual adjustment caps only. $150
 
 
4AGE AW11 AE86 AE82 coil and igniter - A coil and igniter setup from a toyota 4age bigport 16v. Part number 19070-16020 $50

 
Toyota 4AGE Smallport 10.3:1 compression Pistons and Rods - Rebuilding your 2nd series 4AGE bigport engine, want to bump up the compression ratio and add more power? you can fit a set of smallport pistons raising the compression ratio from 9.4:1 to 10.3:1.
These pistons look in good condition, a little bit of carbon build up so a clean would do wonders. They have no visible cracks or chips or damage of any kind. Being from a smallport 4AGE they have 20mm pins so will not fit on early 3 rib 4age blocks as they had 18mm pins, but will fit 7 rib 4age blocks
I used a set just like these in the last 4age bigport build I did and it ran fine. I was thinking about doing it again, but going a differant route. $75

 
4AGE 16Valve Bigport Head AW11, AE82, AE86 - I have my old 16v bigport head, pulled from a running engine. The head was reco'd 50,000km ago. had all valves cleaned and checked, new valve stem seals, was checked for leaks.
the head has been skimmed twice, 5-6thou was taken off each time, so all up 10-12 thou is gone from the head. the dark in the cylinders you can see was due to the piston rings not bedding properly during run in hence why the engine has been pulled appart after 50,000km.
I have all bearing caps and a set of bigport 240 deg cams to go with it. No cam gears or cam covers. $200