Go back to home

turbo base gasket

Author
Post
Essentials Only Full Version
PanMR2
MR2 Enthusiast
  • Total Posts : 114
  • Scores: 1
  • Reward points: 2756
  • Joined: 2011/09/16 11:28:53
  • Location: Adelaide SA
  • Status: offline
2012/07/06 06:20:45 (permalink)
0

turbo base gasket

Where can I find a metal gasket that goes between turbo and exhaust manifold on 1994 3SGTE engine
any help would be very much appreciated
cheers
Pan
#1


3 Replies Related Threads
    MR2QIK
    MR2 Deity
    • Total Posts : 2015
    • Scores: 106
    • Reward points: 3479
    • Joined: 2011/04/07 19:51:15
    • Location: Sydney NSW Australia
    • Status: offline
    Re:turbo base gasket 2012/07/06 10:04:17 (permalink)
    0
    I can't remember for sure if there is one. Toyota most likely will be your best bet since it's not a common T3 flange.
     
    GCG or some other may also be able to help as I believe they sell/hiflow/rebuild CT26's (same gasket).

    MR2QIK - "The Little Car That Could"



    320rwkw @ 19psi (pump fuel, no giggle gas)
    11.96 @ 116mph (with 228rwkw)
    #2
    MRTurbo
    SA Moderator
    • Total Posts : 2894
    • Scores: 81
    • Reward points: 4791
    • Joined: 2011/04/07 19:51:15
    • Location: Adelaide SA Australia
    • Status: offline
    Re:turbo base gasket 2012/07/06 10:17:43 (permalink)
    0
    Wouldn't it be different to a CT2x, as hes got a GT2871R now? i.e. not "twin entry"/scroll etc?

    1990 SW20 GT 3S-GTE Targa
    2001 Honda CBR600F4i

    #3

    EssDub
    MR2 Deity
    • Total Posts : 691
    • Scores: 41
    • Reward points: 2868
    • Joined: 2012/02/09 18:06:20
    • Status: offline
    Re:turbo base gasket 2012/07/06 10:27:14 (permalink)
    0
    Pan - are you still using a CT -> Garrett adaptor from the stock manifold?  If so, a standard multi-layer Toyota gasket will do fine.  Not sure about the gasket on the other side of the adaptor -> turbo, might be a T3/T2 specific one.
    #4
    Jump to:
    © 2025 APG vNext Trial Version 5.5