TVIS elimination

Hey all,
 
Hoes anybody know of any company that makes and sells tvis elimination plates for a bigport 4age?? I can't gut the standard tvis plate, as i don't have one, and would rather buy a pre made unit rather than buy a tvis setup and modify it.
 
Cheers

ATS do the phenolic replacements for the 3S, might be worth an email asking whether they can do them for a 4A.
 
Also I knew there used to be some for sale on US ebay back when I had a Corolla, but a look now reveals nothing unfortunately.

Its an old article, but there are a couple of contacts on the bottom you could try?
 
http://www.autospeed.com/cms/A_110474/article.html
 
Cheers
 

I picked up an old TVIS plate then did this with my milling machine.



 
TVIS plate was like $10 and it only took me a couple of hours on my little milling machine.

Knightrous, that is the most well executed modification to a TVIS plate i have seen in my looking around when toying with the idea, i take my hat off to you on that.
 
Of all the machines and equipment i have access to, a mill is not one of them. I was also too lazy to track down a TVIS plate, hence i have gone the current route.
 
In temporarily converting my car to N/A while i save up for the last few bits and pieces to do my turbo setup, and to get the car on the road again after killing the supercharger, i didn't want to spend the time either, as i am already messing around switching to a mitsubishi evo throttle body for a more effective idle control setup, marginally bigger blade for when i go turbo, and the advantage of it bolting straight up (after you wind the stud out of the manifold and use a bolt instead.)