HOW DO I RESET CLUTCH ACTUATOR MR2 SPYDER

usually a clutch friction relearn is pretty simple.
 
Warm the car up to full operating temp, drive off easily. shift though the gears one at a time then down shift though the gears one at a time. accelerating easily and decelerating easily. generally shift over 3000rpm
 
you really only go up to third gear then back. do this a few times and the ecu should learn the friction point.
 
Full ECU relearn is a different beast but should not be needed for a clutch swap.

2 hours in case there's multiple checks and relearns required maybe, they're just being on the safe side, if it took them even slightly over an hour, they'd probably just prefer to charge for two and get the job done properly.
 
$130 a hour to do that kinda stuff isn't out of the ordinary for a dealership. I usually get charged $110 for any work.
 
Yeah sure it's a lot of coin, but if they actually do good work and you are incapable of doing it yourself or don't have time, it's not such a bad option.
Try not to poo-poo on dealerships for wanting to run a business :P

Ok that's good then cause I took the box off the old motor with the pump and replaced the clutch then put it on with a fresh machined flywheel on the new motor!