HELP - URGENT!!!!!

To Bottom

HELP - URGENT!!!!! (p.30)
Post New Thread
Regular
drb

Turbo manifold for AW11 with 4agze

Hi AllCan anyone help with information as to what manifold to use to fit a turbo to an AW11 with 4AGZE. The plan is to twin charge the car putting the turbo between the supercharger and the intercooler with a bypass valve into the air intake so as the turbo takes over it can draw air in from before ..
1
2015/02/25 23:11:31
brent310

engine will not run. Starts and stops straight away this car has been totally re built. I have no warning light up on instrument panel . have checked all fuses and relays fuel pump no noise heard engine starts a d stops. if I earth out alternator live wi

Electrical..
7
2015/02/21 14:27:49
Carmikey

Air con 'O' rings

Has anyone had any luck replacing their air con 'O' rings that are on the end of the Refridgeration lines (both connect into the compressor). One line is from the 'Evaporator' the other from the 'Condensor'. Before I re-install I would like to replace with new o rings...
4
2015/02/19 08:39:00
xtimmyx

SA - Need to lend/rent AW11 front struts

I need another go at getting my -88 MR2 through Regency to clear the defect and in doing so I'm required to fit new springs to the front (or different struts all together). Does anyone have a pair they're not using and could lend/rent me for a few days? Cheers,Timmy..
2
2015/02/17 23:19:45
brent310

engine

Electrical..
3
2015/02/17 22:33:18
LindsayAW11

AW11 Winking!

When I turn off my headlights a little show starts. My headlights go up and down alternately about six times, then the RH one will stay down with the LH often staying up. Eventually after a few goes, both will stay down. While it looks funny, does anyone know how to fix it?..
5
2015/02/17 17:24:41
PTMR2

Mr2 parts

Hi guys, Am in need of a few things for a road worthy, front and rear struts, power steering rack, rhf ball joint... All parts can be new or used just as long as they aren't leaking etc... Please post if you have any of these or know someone in the Brisbane area that would? Thanks..
1
2015/02/12 08:54:54
92 Hard Top

adaptronic

Need to get pins for the plugs so I can set up boost switch etc. Don't know where to get them...
2
2015/02/07 15:55:30
92 Hard Top

speed sensor

Need a connector with some wire to setup aptronic ECU..

2015/02/06 23:24:40
sussdub

Gen 3 3sgte Fuel Pump Relay + Cluster Issue

After swapping half cut running gear (ecu, gearbox, body wiring harness, dash wiring harness etc) from a 94 gen 3 3sgte I received with a half cut into my 1990 jdm n/a shell I have run into two main issues I cannot explain. I must mention that the running gear minus the body harness and dash wiring ..
6
2015/02/01 20:08:34

<< ..28 29 30 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account