Electrical / Ignition / Fuel Injection

To Bottom

Electrical / Ignition / Fuel Injection (p.5)
Post New Thread
Regular
banner

Lightweight alternator bracket for 3sgte

Also after one on these? Or a shop that can make one in Melbourne?..
4
2018/10/10 10:39:09
TwoDogs

MR2 3SGTE - another No Spark - problem identified and fixed.

Recently my car went from occasional cut-out, followed by worst case, a 3 minute cranking at the traffic lights :o( .. , to a complete No Spark – luckily in my driveway.Went through web threads, and the BGB troubleshooting, measuring resistance at the ECU plugs and everything seemed fine. Much frust..

2018/09/20 13:18:34
MG_MR2

A doozy of a question re identifying this...

Hi All, So in the process of doing work on my car (it's gone a lot more involved than planned) I had the windscreen removed to check the surrounds for rust and re-do the seal. Now while looking around I found this (see pictures - one is with plug removed and other with plug on) just under the windsc..
5
2018/09/12 22:07:01
DamMR2T

DIY Tuning - Logging & Apexi FC

Hi Guys I'm looking at getting into tuning and as I have a Power FC which is plug n play, thought this would be a good place to start. I am considering the FC Hako for the PFC but I have a few questions that I'm sure some of you that are tuning already can answer. 1. Anyone using the FC ..
2
2018/08/26 18:56:56
TwoDogs

Rich Running & Fuel Pressure Regulator

Hi All, From my searching, it seems almost compulsory that Gen2 3sgtes with stock fuel systems run rich.It also seems common that the Fuel Pressure exceeds the BGB specification, so I am about to embark on the “fit a gauge to the fuel rail” exercise to see what’s going on. But first I thought I’d ch..
11
2018/08/21 13:33:19
sussdub

SW20 Solid State Relay Power Steering Issues

Hi All, I have a 91 mr2 with 94 gen 3 3sgte running gear (engine, gearbox, ecu, wiring harness up to kick panel). Ever since I bought the car with the old N/A gear, the power steering light has come up on the dash however Power Steering worked fine. After the swap it continued to work fine for a whi..
7
2018/08/13 12:09:42
LindsayAW11

SW20 Yellow Fog Lights

Where can I get a pair of yellow fog lights for my 92 JDM Turbo?..
1
2018/07/17 09:55:11
DamMR2T

Top feed fuel rail options

Hi guys I'm after a fuel rail for my 5SGTE (gen3 head， st215 manifold). I have Bosch 2200 injectors and had a couple of questions: 1. What top feed fuel rail does everyone use RacerX， OBX， st215? 2. Will 2200cc injectors fit using st215 rail? Does this rail have enough flow? 3. What size injec..
3
2018/07/02 22:23:52
rock

code 31 after gen 2 to gen3 ecu conversion

Hi guys,I've done a gen 2 to gen3 ecu conversion with a berk jumper harness and code 21 and 31 shows up.I know 21 is the oxy sensor, my main concern is 31 which is the map sensor. I have fitted all the gen 3 parts required and they were off the same car in good work condition. Car starts and idles ..
2
2018/06/12 09:43:46
TwoDogs

3SGTE -Does changing the idle timing vary the timing at 7000 rpm ?

Does the ECU vary the ignition timing at 7000rpm based on various sensor information ?or is it simply a calculation against rpm ? The BGB says idle timing for the SW20 is 10o BTDC, but presumes the engine will boost to 11psi and is using 94 octane fuel (according to KO racing - not sure where they g..
2
2018/06/07 15:17:56

<< ..4 5 6 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account