Electrical / Ignition / Fuel Injection

To Bottom

Electrical / Ignition / Fuel Injection (p.33)
Post New Thread
Regular
blacky83

Keyless Entry Module Location?

My sdub has the factory keyless entry (single button remote) and I'm wondering where the control module for this is located. Looking to install an RFID handsfree setup I've got, and it would be nice if I could just piggyback off the module to save a bit of wiring, but that means finding it. Google ..
5
2012/06/27 00:26:15
Blakely

Good Auto Electrician Brisbane - Grange area

Sorry if this question has been asked before but I am looking for a good auto electrician near the grange/wilston area, though will travel further if its near a train line. I have a Jap 1989 SW20 3SGTE and both the Speedo & Tacho have completely stopped working, along with the odometer. I have i..
1
2012/06/22 15:21:05
Admin

Seized injectors

My car runs E85 and I had the engine rebuilt late last year, so it has been sitting around for a long time. It's finally all back together and it won't start. I've figured out that the injectors have seized. They are quite new though I believe that this is a common problem with E85. I have them s..
1
2012/06/17 18:30:27
Ddubtoille

Oil temp gauge sensor location

Hey so I have a Drift oil temp gauge that's pretty much all wired up I just need to find a location to put the sensor. Just wanted to check to see if anyone else has done this and has found a good location for it. Here's a pictures of the sensor to give you an idea http://i1057.photobucket.com/al..
11
2012/06/15 12:26:13
TIPSIDUECE

Gen 2 vs gen 3 fuel system

gen 2 3sgte fuel pump flow rate/capacity? gen 3 3sgte fuel pump flow rate/ capacity? i assume gen 3 has higher flow rate since its running bigger injectors??? could a gen 2 fuel pump keep up with a bored out gen 2 rail, stock gen 2 fpr, with gen 3 540's? running 15 psi on a stock motor, stock tur..
6
2012/05/31 19:32:48
Mrskylighter

Gen 3 3sgte Oxygen sensor replacement options?

Hi all, I'd like to replace the oxygen sensor on my gen 3 (4 wire) and am wondering what options there are to do this? (Gen 2 USDM 4 wire sensor has a different plug btw) It seems as though Denso does not make a direct replacement (Quality aftermarket unit) and I think Toyota would absolutely rape ..
9
2012/05/30 11:24:56
Mr2gtracer

battery discharge

Hey guys, i've just replaced my battery and now the battery discharge dash light comes on. I didn't have this with the last battery, even when it died..... Any suggestions?..
17
2012/05/20 21:05:08
PTMR2

HID Trouble... still

So i installed some phillips 6000k hid on my sw20 and all was good until one of the bulbs stayed on constantly even after turning off the lights. only by disconnecting the power did the light stop. we swapped bulbs over, tried different headlamp connectors but nothing seems to stop it. Now as soon a..
7
2012/05/16 09:08:00
bnicho

AW11 Electrical Gremlins - Headlights, Indicators, Gauges...

I had a weird electrical experience with my AW11 last night. I should say up front the hazzard flashers have never worked since I have owned the car, but I'm used to older cars without them anyway, so it hasn't worried me. Also, being an ex-USA car converted to RHD, it may have had some wiring bo..
2
2012/05/09 10:35:02
bigh

alpine type S 4" Speakers for rear.

Hey Everyone, I want to finish my speaker install and want to do it with as least fuss as possible. Does the Type S 4" fit in without needing a bracket / modification? any reccomendations on where to get them cheap in melb? Currently the best price I have is $88 delivered (I'm lazy and busy). thanks..
3
2012/05/07 01:11:58

<< ..31 32 33 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account