Electrical / Ignition / Fuel Injection

To Bottom

Electrical / Ignition / Fuel Injection (p.19)
Post New Thread
Regular
PrivateJoker

1990 mr2 speedo not working

I removed my dash over the weekend to fix afew thing now my speed isn't working. The needle sits way below 0 The cable is connected properly behind the instrument cluster. I started pulling the dash apart again and notist this cable not connected to anything (will post a pic as soon as I get on m..
7
2014/06/23 05:49:46
kev090997

HELP for Transponder Keys, '98 MR2

Hi everyone, been a long time reader and finally decided to make an account on this forum a few weeks ago.I recently bought a 1998 Rev 5 MR2, car wasn't really cared for by the previous owner, oil was thick and gooey, paint isn't in too good shape etc. etc. etc. The previous owner only supplied one ..
2
2014/06/19 01:31:08
DumpsterMummy

Caltex 98 Fuel vs BP Ultimate 98 Cold Start Issues

Hey guys, Recently I was having some cold start issues with my MR2 (Japanese 1990 MR2 Turbo) The car is also stock apart from a 3" exhaust. On start up the car would either really struggle to turn over, it would sit at the point of just before stalling - stuttering for like 5 seconds before either f..
1
2014/06/07 19:22:07
alexv

Cold start stalls

Heya, So the problem is that in the morning, my mr2 cranks and fires fine, but then the needle quickly drops from ~1500RPM or so down to 0 and stalls. If I give a bit of throttle for a second or two, then it doesn't stalls and the RPMs are steady. It tends to idle a bit high 1200-1400RPM but after w..
25
2014/06/07 11:17:20
thomas108

Instrument panel - instructions to swap to LEDs

I just noticed there must be a couple of blown bulbs on the instrument panel. Is there a step by step how to change them to LEDs anywhere. I may as well if I'm going to the trouble!..
7
2014/06/05 16:11:24
Mirko

Coil on plug conversion for 3sgte with NA head

HI guys, Have a 3sgte with the NA head on it and l want to do the Coil on plug conversion for it and was thinking from research the 1NZZFE coils but then cant find anyone that sells the plate etc. Was wondering if anyone has done this before..
7
2014/06/02 16:02:38
PrivateJoker

fuel gauge only reading 3/4 full

Hey guys I've notist when ever I fill up the gauge only goes to 3/4, also my fuel light isn't working I'm assuming they're two separate issues. Does anyone have any ideas as to what I should look at first?..
5
2014/05/28 19:08:22
BEN77

microtech with avcr no rpm?

Hi guys, i have a microtech LT10c already installed in a recently purchased sw20 3sgte and im trying to get the avcr to show revs and eventually get the boost raised. Problem is the rpm out of the microtech to the avcr - No matter what setting there is no rpm on the avcr. I have googled tacho booste..
3
2014/05/13 19:42:38
Mr2gtracer

Apexi Turbo timer problems

Hey guys and girls, Recently I have seen that when I shut my car off the turbo timer doesn't keep the car running, it just shuts down straight away and I have to restart and shut down the engine again for the timer to kick in. Has anyone had this problem before? Is it a wiring issue or something els..
8
2014/05/13 11:11:07
spudman

Installing HKS type 0 turbo timer

Hi all, just had my 1993 sw20 coverted to turbo, new motor. Have a HKS type 0 turbo timer to install. Does anyone know the color of the ignition wire l have to connect the green wire on the turbo timer harness to? thanks Dave..
2
2014/05/06 09:35:22

<< ..19 20 21 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account