Does anyone have one, That I can buy or hire?

I can get one made. Would anyone else be interested in it after I used it? You can buy it and sell it after or hire it from me. Can I get some feed back please.

Have you spoken to Rhemac in Gawler. Many years ago I found them to be very good with engine machine work.
Prepared to bore and hone to my specs to give the clearances I required. Most of those blokes would be dead by now but they may have taught the new generation. They would possibly have a 3S. torque plate.

Falcon
Have you spoken to Rhemac in Gawler. Many years ago I found them to be very good with engine machine work.
Prepared to bore and hone to my specs to give the clearances I required. Most of those blokes would be dead by now but they may have taught the new generation. They would possibly have a 3S. torque plate.

Thanks Doug. I will check it out.

Rhemac doesn't have one.

Finally work out how to install Sard 63507 800cc fuel injectors into Gen II fuel rail which is bore out to 8 to 10mm, have to cut the yellow bit off and add the alloy sleeve, then change o-rings around. Then take the thick o-ring one off the 430cc and put it on the new injectors. All done, happy now. Money Save! Had these sitting in shed for a few years.

I have had a 3sgte honing torque plate made. It's for hire $150.00 per job plus shipping and return shipping. These cost $600 in the US. If you want the perfect piston and cylinder seal you need this Honing Torque plate.

"Bump"