Im running Versus Zenkais in Bronze, 

Front: 17x8 +30 (was 35 but has a 5 mm spacer on it) with 205/40 rotalals. they aren't good at all.
Rear: 17x8 +15  with 225/45's on it. Bridgestone Potenza's I think

 
 

 
Not shown in the last picture is the rolled guards which were also flared slightly. I flared the rears out about 10mm's to make it legal and reduce scrubbing, and the fronts only have about a 3mm flare. Did it with a guard roller and turned out mint

The front's at +35 didn't clear the coil overs so i had to run a slip on spacer which has heaps of room

And yes, the rolling diameter is hugely off but for some reason the speedo still indicates the correct speed? I've checked with both GPS and friends driving beside me so i dont even know how that can be possible :P 

Monika
...
If you no longer have them, can you tell me what brand they were?

http://www.workwheelsusa....tegory=27&wheel=80
Jay had Work Emotion CR Kai's last I heard he was selling them?
 
 
Alternatively - there is a very similar styled wheel.
 
http://www.rotaaustralia....orque_c65201_65411.htm
Rota Torque
 
Eric that looks pretty damn good - much better then what you had before!

Can you fit r33 gtr wheels on the mr2 sw20

Possible but certainly not ideal. Due to the fronts.

Wheel: Deep dish steelies
Specs: 16x8 +0
Tyres: 195/45 R16
 

 

 

Hi there, I have a set of rims 19 inch x 9.5, +12 offset, will these fit my 94 mr2? I would love some advice, if you can help me out it would be much appreciated!

19s are too big for the front on an SW20. The rolling diameter is so large that you wouldn't be able to turn the steering wheel to full lock without the tyres hitting the wheel arches.

Will 18x9.5 +25 wheels on a 245/40/18 tyre fit? 

I just threw those numbers into a calculator and compared it to my setup.
Going off the calculator the set up your looking at will poke 6.7mm further out of the guards than mine does and I would probably try to go for a 35 series tyre as the 40 series has a larger rolling diameter and my rolling diameter already has the speedo out by a little.

Nik_Lee
I just threw those numbers into a calculator and compared it to my setup.
Going off the calculator the set up your looking at will poke 6.7mm further out of the guards than mine does and I would probably try to go for a 35 series tyre as the 40 series has a larger rolling diameter and my rolling diameter already has the speedo out by a little.

Thanks for that Nik. Do you think I would run into any problems with actually fitting the wheel on my car?