Hi guys I am about half way through race prepping my 1992 sw20 it was a n/a and I have brought a gen 3 3sgte and gen2 box I am now after drive shafts and hubs. My question is what hubs will fit and drive shafts I know their is some differences in the n/a ones to the turbo ones not including obviously the strength. It is proving a little hard to source the last few pieces of the puzzle if any one could point me in the right direction it would be much appreciated. Also does anyone know of any fabrication shops that are competent on installing a camms approved cages in sw20's. Thanks guys.

Regarding roll cage, what state are you in? 

He's in vic
Also check this thread out http://www.mr2australia.c./mr2play/tm.aspx?m=96461

Speak to Greg at Fabraications in Braeside. www.rollcages.com.au 

+1 Fabraications

+1 for the guys at fabraications.

Cheers guys I will give them a ring.

No one with any info on a good place to source drive shafts and hubs?
I have exhausted pretty much every Avenue as far as wreckers go in vic... and after being bit on the engine. I was told it was out of a low k import! yeah right An import that was running 40 psi with a crap load of advance and a huge turbo lol so all I really scored was a few good bolt on hks parts that really haven't balanced out the full rebuild haha woops. Definitely not the first and won't be the last idiot haha.

So not really keen on interstate buying again. However did meet an awesome engine builder if anyone needs one in the future. Any help would be greatly appreciated.

Monkey Wrench Racing may be able to help with gearbox and driveshaft bits.
Have a look here:
http://www.monkeywrenchracing.com/index.php?cPath=317&sort=2a&page=2
 

What sort of racing are you prepping this for? Targa?

It is going to be a circuit car.