2015/11/03 12:34:35
zmit
Hey guys, I'm after a single gen3 3SGTE conrod. I just dropped the engine off at the machinist and has suggested replacing the rod rather than machining it down.

ADL preferred, but probably not going to happen!
2015/11/03 13:52:32
zmit
Still looking.....
2015/11/03 20:53:02
Guest
Dvsmr2 has heaps of gen3 parts after stripping his fully built engine down, only after a short use, his parting as he is going a different direction (v6 boooo)
2015/11/04 18:05:08
zmit
Thanks for that... maybe not Pauter rods though. a little beyond my means.
 
I've checked part numbers for the conrods. gen3 3SGTE and 3SGE rods are the same. (as are gen2 3SGE and 3SGTE rods)
2015/11/05 06:24:20
banner
I got a set of rods with brand new Je Pistons. Gen 2 3sgte, so I'm not sure if appropriate.
2015/11/05 08:00:36
zmit
Hi Banner,
Are they standard rods?

My current setup is forged pistons (CP from memory) with Gen 3 standard rods. Gen 3 rods were stronger than standard Gen 2, so I obviously don't want to go backwards.
2015/11/12 07:06:37
Road and Track
we have several. if you still chasing, email me the exact weigh so i can get one thats very close. any old rod will not do. Toyota fit them to engines in matched sets and there can be 20gm difference between sets
 
roadandtrack@bigpond.com
 
 
© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Use My Social Media Account