Noooo not cool! Filling with water..... Damn!!!
Easy job man all did was:
> unscrew the A-pillar trim starting near the fender
> peel and lift the door sill rubber out of its alloy carriers - partly removing it
> unscrew the remaining A-pillar screws from the alloy sill carrier (now visible because we partly removed the door sill rubber)
> unscrew the alloy sill carrier - unslot it towards the rear of the car if needed.
>>>
> follow the windscreen edge trim around to the B-pillar, wiggle and slide the radiused exterior finisher
> pull up and lift the long exterior finisher removing it and BAM!!! Your A-pillar trim can be removed and the windscreen edge lifted, it should pop straight up and out - or you can gently caress it out with flat plastic bicycle tyre levers! lol there flat and soft - wont damage anything. It just sits in there nested via some plastic locators which sink into the windscreen rubber gasket.
> clean it and check it and your ready to seal your windscreen!
** Give us a yell if you guys want a hand sealing the windscreen one weekend was easy enough only 1hour-2hour's to do a good job with everything layed out ready!
woot woot
HOw did you take off the windscreen rubber? My is leaking also and holding water like a boat in the doors. All my trims need to be restuck down. Did you heat it up then peal it off? I have no idea how to do it
hahaha you crack me up man, hit us up if you want to fix it "san" sticky tape! i was tempted to just electrical tape it but the sun was out so made the most of it.
Jealous bout your tyre voucher man!!! Spot on caught the left rear lip and scored the tyre taking chunks....
RdS
guard rolling cargnage? arrgh...
good job with the windscreen trim too.. mine is so goddamn heinous. silicone, stickytape, etc.. and about a foot of the screen. super jealous.. <_<
meisters look slick as too! whats the sizes/offsets?