General MR2 Stuff

To Bottom

General MR2 Stuff (p.21)
Post New Thread
Regular
Sw2091

Mr2 custom guage faces

Does anyone make custom guage faces for the mr2 would like something a bit different to my factory ones. Cheers Sent from my GT-I9505 using Tapatalk..

2017/03/30 20:53:51
Reddtarga

Recommended MR2 repairers Melbourne

Although I don't need one at the moment, does anyone have any recommendations for places that are familiar with working on MR2's, and charge reasonable rates in the Melbourne metro area?..
1
2017/03/21 11:43:19
MG_MR2

Suspension parts advice

Hi there, Just seeing if anyone has some advice re where to find suspension components in Sydney for SW20s? I'll be pulling my suspension out in a while and likely putting in new progressive springs, testing the shocks etc I'm finding it difficult to find common parts such as strut ..
3
2017/03/17 07:45:30
dave

New Owner

Good Morning.I just purchased a MR2 Targa Top i was told it is 1991 but the registration papers say 1990.As i do not know anything about this car can anyone help me with a few problems the brakes shudder and are not very good and between 100kmh to 140kmh the steering wheel shakes and vibrates badly...
16
2017/03/14 09:09:03
grl570810

Erratic speedo???

Hi All,Looking for some advice - my speedo has started acting weird in the last week or so. When I first start up it goes all the way to 260kph for a few seconds, then sits at 40kph whilst I am at a standstill. Then when I start moving it zooms back up again - I was apparently doing 190kph the other..

2017/03/09 15:49:29
wiz

Turbo motors

I have a friend who has a 1998 SW20 Turbo import who requires a full wiring loom to the ECU. Are these a 3GSTE loom or is there a 4GSTE loom for the Gen4? Sorry...don't know much about the turbo models...
2
2017/03/05 19:36:36
jlee165

Blow Off Valve Cylinder?

Replacing my rocker cover gasket today I managed to destroy the cylindrical part circled in the picture I have attached. If you can't tell the picture is of the blow off valve. I would like to know what the part is so I can replace it. Thanks in advance!..
1
2017/03/02 15:10:19
Stinky

MR2 Parts

Just a noob so I am not sure if this is helpful, Just Toyota Wrecking in Wingfield SA has an MR2. Look like it has been picked over heavily but still has a few parts and prices are reasonable. No motor or box. I grabbed a lot of little stuff to help my project along. https://s21.postimg.org/tjoh..

2017/02/17 21:05:58
trdk20

Mr2 k20 project

Hi guys , I'm looking to do a k20 big turbo conversion on one of my mr2's, Anyone know who would be best to talk to workshop wise or backyard guru in Australia. .or preferably in the canberra /sydney region. I'm talking with a few local workshops ..but thus far mr2's are a little scary to them. ..
22
2017/02/15 11:21:53
Nik_Lee

Recaro Pole Position

Hi Guys, Just wondering if anyone on here is running a set of Recaro Pole Position seats in their 2? I am curious on what the fitment is like in the MR2 with sliders as I would like to run a set in mine but I would need sliders and I don't want to end up with a seat position that is too high.If anyo..

2017/02/13 12:44:34

<< ..19 20 21 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account