HELP - URGENT!!!!!

To Bottom

HELP - URGENT!!!!! (p.54)
Post New Thread
Regular
Adrian

Need radiator hoses ASAP

Hey guys, I'm in need of the two little hoses at the front of the car that connect to the radiator. It's a 97 sw20 NA in case there are differences between year models. I have a track day on the 25th so I'll be needing the hoses within the next few days. Reply here or PM if you have anything for me...

2013/04/19 17:47:16
Eric

bad handling characteristics

Hey guys recently got a wheel alignment done by bridgstone select. I asked them to raise the coilovers 5mm's all round at the same time, but they gave up after attempting too. Since then though the car has been nothing but problems After this event, the car has been all over the road. every time i h..
18
2013/04/19 14:14:57
Dudeman

RDA Rotors - which way should they face?

Bought these ages ago from gorilla, do these rotors face this way...http://i64.photobucket.com/albums/h161/hard_kore_drummer/slotteddiscRH.gif! or the 'other' way. I had mine installed, and the are the 'other' way. ABS works fine at speed but triggers at very slow speeds. Mech thinks the way the dis..
7
2013/04/17 20:14:49
Dudeman

Can cable drive speedos be recalibrated?

Ok, so I searched high and low for ages for the cable driven TRD speedo. No luck. Anywhere. In the world. So I sourced an ADM cable drive 260kph speedo, plonked it in, not accurate. It reads about 12% under from the quick drive I just had. Checked it against a gps which are pretty much 1-2kph on the..
4
2013/04/17 17:28:34
el filthy

will s15 225/50/16 rims fit mr2

hey guys got some rims to get my car rego'd and turns out they scrape my suspension, so wondering if s15 rims with 225/50/16 tyres will fit with no issues...
2
2013/04/09 23:58:04
LindsayAW11

Help- Quaife LSD (QDF17E) to AW11

I'm looking at fitting a Quaife ATB LSD to my 4AGZE AW11. What axles do I need in order to fit this diff? Will this diff fit the 4AGZE gearbox? Any help will be appreciated...
2
2013/04/05 11:36:47
Cruiser97_80

Coilover spring rates

I am currently building myself some coilovers for my SW20 (3sgte). Sleeve kit + koni inserts. I am ready to order my springs and want some peoples thaughts and experience with spring rates.I'm not real concerned about comfort as my car is only used for car club events + travel to and from events.Eve..

2013/04/04 19:55:10
stuka

How To Remove Boot Spoiler?

Trying to remove the 1990 bootlid spoiler, its full of water! I have removed the nuts from inside the boot and I know there are a couple of clips holding the spoiler in place. To release the spoiler from the clips on the bootlid, do I lift the spoiler up vertically from the lid or pull horizontally ..
2
2013/03/31 19:39:03
stuka

Route of Boost Hose to Stock Boost Gauge

I want to fit a decent boost gauge and need to tee into the house that feeds pressure from the inlet manifold (I assume) to the stock boost gauge on the cluster. Anyone know the route this takes, cant seem to find it?..
3
2013/03/29 14:19:51
P E T E

Part Number required for both rear CV Boot's

Guys, I checked the online Parts catalogue and there are 2 part numbers for the CV boot kits. Any idea's on the differences between them? (I thought they would have been the same through all of the revisions) I've got a 1992 JDM with the later brakes, crossmember, LSD Turbo. Cheers!..
7
2013/03/25 16:17:47

<< ..52 53 54 .. - Powered by APG vNext Trial

© 2026 APG vNext Trial Version 5.5

Use My Existing Forum Account

Username: Password:

Use My Social Media Account