Hi all 

I am selling my Megasquirt DIY PNP out of my old AW11 which had a bluetop 4AGE. I no longer need this a I have decided to go for a different ECU on my 1MZ. 

This has the v1.5b board, it is fully assembled and ready to go. there is a base map on there that got my car running but you may need to build your own.

It currently has the Nippondenso 92 pin plug installed, but I also have a Nippondenso 42 pin plug that was originally on there

The ND 42 Pin will fit 4A series engines, R series engines
The ND 76 pin it will fit all 3S series engines + black and silvertop 4A's, and may also fit VZ series engines

Please note that there may be other installation requirements for your car.
It also comes with spare cases and other components aswell as a tuning cable.
 
$350 for the whole kit and caboodle.  Can also include a mini laptop for tuning for extra
Located Brisbane but I am willing to post at buyers expense

Thanks

-Eric

Price drop - $400- and bump, need to buy a supercharger

What would be involved in hooking this up to a gen3 3sge? Any extra parts needed or is not ready to be plugged in and tuned?

Hey Adrian

You would need to desolder the current Break out board and solder in the Nippondenso 92 pin break out board. 
To do this correctly you will need to create a conversion table in excel so you know what wire goes where. I have one of these for a gen 2 3sge and is honestly not that hard

After you wire up the board, you will need a wideband 02 sensor if you plan on tuning the car yourself, if not you would take the car and ecu to a tuner and ask for it to be tuned

Hope that answers your questions :)

Bump and price drop 

$350

I have also soldered it up so that it connects to the 3sge loom. Tested all the inputs and they work

which 3sge. gen1,2,3 all have different ecu pin/plugs.

just_ace
which 3sge. gen1,2,3 all have different ecu pin/plugs.

Doesn't matter, you just change the jumper wires inside the ECU to match the loom plugs.

they have physically different plugs.

https://www.diyautotune.com/diypnp/models.html
Nippon Denso 76pin Unassembled Kit
Toyota MR2 3SGTE 1991 - 1995
Also does Celica 3SGTE 1990 - 1991
 
Should work for these.
 

ok, so its pnp for a gen2 3sge and 2/3gte.

gen2 ge/gte and gen3 gte are the same, (and 92+5sfe)

gen3 ge, gen4 ge/gte are 4 plug.

gen1 ge is old, maybe like 4a.