Hey guys,
So I recently bought some new rims cause my old ones got bent and the new wheels are sitting a bit too close to my coils.
 
I'm deciding to get some extended studs and run some spacers and just need some info on the stud dimensions like the knurl/spline, hub size, etc of an 1990 SW20
 
Any recommendations would help, thanks :) 

Hi Mate, 
depending on what size you want to extend out to, these are great.
http://www.ebay.com.au/itm/OEM-HUB-CENTRIC-10MM-WHEEL-SPACER-ADAPTERS-5X114-3-60-1MM-CB-12X1-5-EXTEND-STUDS-/181078685796?pt=Motors_Car_Truck_Parts_Accessories&hash=item2a29217864&_uhb=1
 
I purchase a set of these, only wanted 10mm but they stock right out to about 30mm.  There are also hub centric, not just wheel spacers.

Hi Rogerlam,
There has been previous discussion on this forum about Land Cruiser studs being the same as SW20 studs but a little longer. Like about 5 mm.
Others may have more detailed knowledge.

Carmikey
Hi Mate, 
depending on what size you want to extend out to, these are great.
http://www.ebay.com.au/itm/OEM-HUB-CENTRIC-10MM-WHEEL-SPACER-ADAPTERS-5X114-3-60-1MM-CB-12X1-5-EXTEND-STUDS-/181078685796?pt=Motors_Car_Truck_Parts_Accessories&hash=item2a29217864&_uhb=1
 
I purchase a set of these, only wanted 10mm but they stock right out to about 30mm.  There are also hub centric, not just wheel spacers.

 
Awesome, exactly what I was looking for. I'm currently running some OEM Nissan BBS mesh wheels with +40 offset so I might need some hub centric rings but other then that I think that might be the one to go with.
 
By any chance, do you know how long the studs are and wht the spline/knurl diameter is? Can't seem to find them on the ebay ad

FYI, off the top of my head, the standard SW20 wheel studs are all M12x1.5, 40mm long, with 14.2mm knurl diameter. I'll double check that later, but I think it's correct.

robk
FYI, off the top of my head, the standard SW20 wheel studs are all M12x1.5, 40mm long, with 14.2mm knurl diameter. I'll double check that later, but I think it's correct.

Oh ok, will 0.1mm in the knurl make a difference?
There's some extended studs for nissan from gktech that are 14.3mm and M12X1.25.
I'm assuming that the thread pitch won't matter as long as I use the correct lug nuts.
 

14.3mm knurl will be fine.

robk
14.3mm knurl will be fine.

Awesome, just ordered everything and can't wait to put it all on :D

^^just make sure the Centre bore (CB) is 60.1mm.  That is the original size.

Carmikey
^^just make sure the Centre bore (CB) is 60.1mm.  That is the original size.

yep, ive bought some 60.1 - 66.1 hubcentric rings to make sure that the wheels will fit perfectly