I thought this could be useful to anyone who searches the forum for info on bored-out gen 2 fuel rails, so here are a few pics of mine (done by Road and Track in Ipswich, I think they increase the bore of the rail from about 4mm to 7mm diameter):

This one shows where the fuel rail bore feeds into the side-feed injectors..


This one shows where they weld it up afterwards (there is normally a little welch plug there)..

Woohoooo my Full-Race exhaust manifold and dump pipe just arrived!
They look even better than the photos on their website!

EDIT: these turned out to be the wrong parts! Full Race sent a Gen 3 manifold instead of Gen 2, and also I should have ordered a 4-bolt dump pipe instead of V-band (that one was my fault). Both of these parts are being sent back, and Full Race are sending the correct parts ASAP. The correct parts will look very similar anyway.

Full Race Gen 3 (incorrect, but still beautiful) exhaust manifold:

love it!

Why do i get these parts for you and not myself?? :P

quote:

---

Originally posted by dylmrt

Why do i get these parts for you and not myself?? :P

---

Good question. You take all our monies, why not spend them on your own car [:x)] jk.

Thanks again for organising many of the parts for my rebuild Dylan! I've got all the major stuff now, and my mech will continue working on my car again tomorrow!

Brb, picking my jaw up off the floor [:u]

quote:

---

Originally posted by Lumix

Brb, picking my jaw up off the floor [:u]

---

Mine's still stuck there.

Thanks mate!

Looks good dude.

very sexy piece of engineering!

daymn that's nice!
Looks like a similar build to KO Racing... I've been drooling over that for a while.