My god you will busy. Car looks great though!

Damn, my MTC preparation list is getting bigger.... Late nights ahoy!

• Contact Dennis about NEVO pulley 

• Finish Flares and cutting wheel arches
• Service whole car (fluids, filters etc etc)
• Fit Oil cooler + adaptor
• Wire up gauges and senders
• Swap street tires to steelies, semi's to grids.
• Paint Steelies white
• Weld up new seat rails and fit bucket seat
• Weld up harness bar and fit harnesses
• Get wheel alignment
• Fit rear braided lines and bleed brakes
• Strip boot carpets, liners and air pipes
• Mount ECU properly to firewall
• Fix ignition coil issues (setup up on relay?)
• Swap over rear left tie rod from SkidDub
• Fit new B pipe and weld up exhaust
• Build and fit 6 speed gearbox
• Make rear camber tops

dennis the menaceContact Dennis about NEVO pulley

 
Will give you a call tonight, I've been interstate for two days.

Wait wut? Who has a Nevo? *mewants*

Don't worry I remembered Aaron had a Nevo and wanted to sell it, I could have gotten it months ago but I'm all out of cash.
 
Hopefully MRP develops his GZE pullies sometime in the near future. Takes his time but at least that allows me to recoup rebuild funds.

If people were super-desperate for crank pullies, I have a contact that could machine custom ones up on a CNC lathe. Cost would probably be comparable to buying a second hand pulley despite the purchase of quality materials for the job.

I'm not desparate, I just want one that's got a good keyway, and harmonically dampened.
If I can get them new (which MRP are promising) I'll prefer that route, otherwise I'll just pick something up when I have the cash.
 
reckon your contact could make them Cusco style? I.e take a factory pulley and add an extra ring on it to make it the desired diameter?

Much happiness, I've been able to truly utilize my shed...
 

 

• Finish Flares and cutting wheel arches
• Service whole car (fluids, filters etc etc)
• Fit Oil cooler + adaptor
• Wire up gauges and senders
• Swap street tires to steelies, semi's to grids.
• Paint Steelies white
• Weld up new seat rails and fit bucket seat
• Weld up harness bar and fit harnesses
• Get wheel alignment
• Fit rear braided lines and bleed brakes
• Strip boot carpets, liners and air pipes
• Mount ECU properly to firewall
• Fix ignition coil issues (setup up on relay?)
• Swap over rear left tie rod from SkidDub
• Fit new B pipe and weld up exhaust
• Build and fit 6 speed gearbox
• Make rear camber tops
• Setup Launch Control and Flat Shift