Chasing two parts from an AW11 shell - the mounting area for the rear vent (behind drivers door) with about 100mm of steel on either side, along with a vent/base and also a good condition front reinforcement bar (black and bolts to chassis). Prefer in Bris but will travel.

i have a rolling shell. see my facebook page

Still looking for these pieces.
Cheere

Hello,            are you looking for the whole mounting area for the side vent?
                    do want a series 1 or series2 side vent?
 
                          I have a right hand rear quarter panel cut that has one side of the mounting area for side vent(the side nearest wheel arch).....$50
                                                      OR
 
                          I have a bare half cut.Nothing bolted to it.Has been cut along roof and along floorpan leaving a complete half cut.Was going to make into a barby but I have two of them and only need one barby.No panels,lights or wheels etc....$150 and I will include a side vent(when I know which one you need).It also depends on how much metal you actually need-we may be able to work something out if you only need a small bit of the rear cut. 
 
                     Other panel cuts include a targa top roof cut and both floorpans and left side rear quarter and back tail light panel.
                      
                       Parts are Dinmore 4303 queensland...well most of them.Some bits are still at Goodna 4300.
 
                             Thank you....skip.
 
                                
 
       
 

Guys I am still chasing these - nothing like people who are keen for sales and then never reply when you're on your way to pick them up.
Cheers

l have a vent available in primer $50.00
located in melb 0411288027
Cheers Charlie

i have shell that i will be scrapping you can cut whatever from 

Where are you Milan?

kallangur north of brisbane